Abstract:Hydraulic fracturing techniques are often applied to form permeability enhancement zones near boreholes and/or wellbores in tight low-permeability reservoirs to improve their extraction efficiency. As conventional hydraulic fracturing techniques often generate high breakdown pressure and induced seismic potential, novel alternative production enhancement techniques (such as pulse hydraulic pressurization) have been proposed. However, their applicability requires further verification. Therefore, this study conducted hydraulic fracturing tests of coal under three test schemes: conventional hydraulic fracturing (CHF), stepwise pressurization hydraulic fracturing (SPHF), and stepwise pulse pressurization hydraulic fracturing (SPPHF), considering the true triaxial stress state of an actual coal seam. The results showed that the breakdown pressure of coal decreased with an increase in the horizontal stress difference ( σ 2 - σ 3 ). Moreover, the pulse pressurization produced more intergranular fractures and caused a large number of particles to be conducted as a stress concentrator at the fracture tip spalling, which promoted the unstable propagation of fractures, which decreased the breakdown pressure of coal. The abnormally high breakdown pressure in the SPHF experiments is likely due to the obstruction of high σ 2 to the fracture propagation rate and fluid injection, which intensifies the fluid hysteresis effect and the stable fracture development and expansion during the pressure-maintaining stage, thus increasing the breakdown pressure. To describe the relationship between the variation in the breakdown pressure and fracture evolution characteristics, we introduced the equivalent characteristic length l and established a breakdown pressure prediction model based on the tensile stress criterion, which shows effective prediction of the breakdown pressure in different test schemes. Anisotropic principal strain appeared under different injection schemes. During the CHF and SPHF experiments, fluid injection deformed the σ 1 direction by compression and the σ 3 direction by expansion. In the σ 2 direction, the deformation transitioned from expansion at a low stress level to compression at a high stress level. The deformation in the σ 2 direction was always compressive in the SPPHF experiments. Continuous and pulse pressurizations can promote the deformation and fracture development. For the fracture morphology, the coal in the CHF experiments was dominated by a single tensile fracture, and macroscopic shear fractures were formed in the SPHF and SPPHF experiments owing to the continuous stimulation of fluid pressure to the bonding of particles and the weak surface structure, such as bedding and cleats during the pressure maintenance and pulse, and the fragmentation effect was significant and accompanied by obvious particle spalling.

Simulation Study of Characteristics of Hydraulic Fracturing Propagation of Low Permeability Coal Seam

Numerical Simulation of Crack Initiation and Propagation Evolution Law of Hydraulic Fracturing Holes in Coal Seams Considering Permeability Anisotropy and Damage

A numerical investigation of hydraulic fracturing on coal seam permeability based on PFC-COMSOL coupling method

A fluid–solid coupling model for hydraulic fracture of deep coal seam based on finite element method

Fracture propagation and pore pressure evolution characteristics induced by hydraulic and pneumatic fracturing of coal

Influences of clean fracturing fluid viscosity and horizontal in-situ stress difference on hydraulic fracture propagation and morphology in coal seam

Investigation of the influence of gas fracturing on fracturing characteristics of coal mass and gas extraction efficiency based on a multi-physical field model

Quantitative Study on Coal Permeability Evolution with Consideration of Shear Dilation

Research on the factors influencing the width of hydraulic fractures through layers

An Analytical and Numerical Analysis for Hydraulic Fracture Propagation through Reservoir Interface in Coal-Measure Superimposed Reservoirs

Numerical simulation of a coupled gas flow and geomechanics process in fractured coalbed methane reservoirs

Experimental study on deformation and fracture characteristics of coal under different true triaxial hydraulic fracture schemes

Numerical simulation of hydraulic fracturing in coal seam for enhancing underground gas drainage

Investigation of Hydraulic Fracturing Crack Propagation Behavior in Multi-Layered Coal Seams

The propagation of hydraulic fracture in layered coal seam: a numerical simulation considering the interface thickness based on the distinct element method

Hydraulic Fracturing Treatment of Low-Permeability Coal Seam Gas Reservoirs with Finely Layered Coals

Numerical simulation of fracture propagation in deep coal seam reservoirs

Simulation Study on of Characteristics of Hydraulic Fracturing Propagation

Study on H-shaped Fracture Propagation and Optimization in Shallow Dull-Type Coal Seams in the Hancheng Block, China

Propagation and distribution of shear and tensile hydraulic fractures affected by frictional coal beddings

Research on main controlling factors and its influencing laws on hydraulic fracture network in the fractured soft and low-permeability coal