Linear Strain Sensor Made of Multi-Walled Carbon Nanotube/epoxy Composite

Shuying Tong,Weifeng Yuan,Haidong Liu,Alamusi,Ning Hu,Chaoyang Zhao,Yangzhou Zhao
DOI: https://doi.org/10.1088/2053-1591/aa9440
IF: 2.025
2017-01-01
Materials Research Express
Abstract:In this study, a fabrication process was developed to make the multi-walled carbon nanotubes/epoxy (MWCNT/EP) composite films. The electrical-strain behaviour of the films in direct and alternating current circuits were both tested. It is found that the direct current resistance and the dielectric loss tangent of the MWCNT/EP composite films are dependent on the strain and the weight fraction of the carbon nanotubes. In an alternating current circuit, the test frequency affects the impedance and the phase angle of the composite film, but it has nothing to do with the change ratio of the dielectric loss tangent of the film in tension. This phenomenon can be interpreted by a proposed equivalent circuit model. Experiment results show that the change rate of the dielectric loss tangent of the MWCNT/EP sensor is linearly proportional to the strain. The findings obtained in the present study provide a promising method to develop ultrasensitive linear strain gauges.
What problem does this paper attempt to address?