Abstract:More than 20 million tons of ladle furnace slag are produced annually. This slag is mainly treated by stockpiling; however, stacking results in dust and heavy metal pollution. Utilizing this slag as a resource can reduce primary resource consumption and eliminate pollution. In this review, existing studies and practices related to slag are discussed, and applications for different slag types are analyzed. The findings reveal that under alkali- or gypsum-activated conditions, CaO–SiO 2 –MgO, CaO–Al 2 O 3 –MgO, and CaO–SiO 2 –Al 2 O 3 –MgO slags may act as a low-strength binder, a garnet- or ettringite-based binder, and a high-strength cementitious material, respectively. Partial replacement of cement with CaO–Al 2 O 3 –MgO or CaO–SiO 2 –Al 2 O 3 –MgO slag can adjust the settling time. Meanwhile, CaO–SiO 2 –Al 2 O 3 –FeO–MgO slag combined with fly ash can be used to prepare a high-strength geopolymer, and CaO–Al 2 O 3 –MgO and CaO–SiO 2 –MgO slags may yield high carbon dioxide sequestration percentages. However, the aforementioned applications could lead to secondary pollution because these slags contain heavy metals and sulfur. Removing them or suppressing their dissolution is therefore of significant interest. Reusing hot slag in a ladle furnace could be an efficient utilization strategy because it can recover heat energy while utilizing the components of the hot slag. However, adopting this approach necessitates the further development of an efficient method for removing sulfur from hot slag. Overall, this review elucidates the relationship between the utilization method and slag type and identifies future research directions, thereby providing references and guidance for future research on slag utilization.

A Review of Granulation Process for Blast Furnace Slag

Research status of centrifugal granulation, physical heat recovery and resource utilization of blast furnace slags

Optimizing heat transfer and solidification crystallization in dry granulation of blast furnace slag

Granulation performance by hybrid centrifugal-air blast technique for treatment of liquid slag

Experimental investigation on granulation characteristics and waste heat recovery of molten slag in gas quenching dry granulation technique

Research progress on granulation process of iron and steel slag

Cooling and phase evolution of a molten blast furnace slag particle

High-temperature Analogy Experimental Investigation on Dry Granulating Characteristic of Rotating Disk for Waste Heat Utilization of Molten Slag

A hybrid cooling system to enable adhesion-free heat recovery from centrifugal granulated slag particles

Heat Recovery from High Temperature Slags: A Review of Chemical Methods

Centrifugal-Granulation-Assisted thermal energy recovery towards low-carbon blast furnace slag treatment: State of the art and future challenges

Techno-Economic Analysis of a Novel Full-Chain Blast Furnace Slag Utilization System

Generation, utilization, and environmental impact of ladle furnace slag: A minor review

Effect of Oily Sludge Treatment with Molten Blast Furnace Slag on the Mineral Phase Reconstruction of Water-Quenched Slag Properties

Three-Stage Method Energy–Mass Coupling High-Efficiency Utilization Process of High-Temperature Molten Steel Slag

A New Process on Efficient Utilization of Melted Slag

The viscosity, crystallization behavior and glass-ceramics preparation of blast furnace slag: A review

An efficient molten steel slag gas quenching process: Integrating carbon solidification and waste heat recovery

Deep insight into phase transition and crystallization of high temperature molten slag during cooling: A review

Recycling of iron and steel slag for carbon reduction and low‐environment load application

Analogue Experimental Investigation on Ligament Granulation of Molten Slag in Various Rotary Disk Configurations for Waste Energy Recovery