Abstract:In order to study the characteristics of fire smoke spread and temperature distribution of a large indoor pedestrian street under different heat release rates and smoke exhaust modes, this paper focuses on the analysis of fire smoke spread, visibility, smoke temperature distribution and variation curves in an atrium. This paper uses a numerical simulation method to conduct research. PyroSim fire simulation software is used to calculate this project, which is based on a full-scale experimental design scheme. The numerical simulation results show that under the conditions of higher heat release rate, the smoke spread rate is greater than that under the conditions of lower heat release rate. Furthermore, the average temperature of smoke in the atrium is also greater, up to about 400 °C. The conditions of a higher heat release rate also show the characteristics of faster generation, faster spread and a larger volume of smoke. When the smoke exhaust system is turned on, the thickness of the smoke layer and the smoke temperature decrease. There then comes a situation where the stabile section of the fire ends in advance. The simulation results of vertical temperature distribution in an atrium can fit the modified McCaffrey plume model in any case. Under all cases, the smoke temperature reaches the maximum directly above the fire source. The horizontal dimensionless smoke temperature rises under the atrium roof, and decreases exponentially with the dimensionless distance from the fire source. The greater the heat release rate of fire source is, the smaller the attenuation coefficient is, with a more than 50% change. When the smoke exhaust system is turned on, the smoke flow accelerates and the smoke is cooled rapidly. Thus, the attenuation coefficient increases. Additionally, the effect of mechanical smoke exhaust is better than natural smoke exhaust, because mechanical smoke exhaust makes air flow and heat exchange more intense. The variation amplitudes of the attenuation coefficient under natural smoke exhaust and mechanical smoke exhaust are 13% and 22%, respectively.

Differential Diffusion Effects in Numerical Simulations on Smoke Toxicity Evaluation

An Evaluation of Gas-Phase Micro-Mixing Models with Differential Mixing Timescales in Transported PDF Simulations of Sooting Flame DNS

A DNS evaluation of mixing and evaporation models for TPDF modelling of nonpremixed spray flames

3D Numerical Simulation of Smoke Flow in Long Tunnel Fires

An Approach for Predicting the Toxicity of Smoke

Improved N-gas Model for Smoke Toxicity Assessments

Modeling Fire-Induced Smoke Spread and Carbon Monoxide Transportation in a Long Channel: Fire Dynamics Simulator Comparisons with Measured Data

Computational Simulation of Smoke Temperature Diffusion in High-rise Buildings Fires

Establishment of a New Dynamic RRC Model in Smoke Toxicity Evaluation and Engineering Application

Effects of Differential Diffusion on Flame Structure of Non-premixed Ammonia/Methane Combustion

Numerical Simulation of Smoke Diffusion for the Generator Exhaust System of Semi-Submersible Platform

Numerical study of radiation model and diffusion effects on combustion in porous media

A Study on Numerical Model Uncertainty of Smoke Concentration in Fire Simulation

Experimental Study and Numerical Analysis on the Smoke Toxicity Transportation Within Typical Building

Numerical Investigation of Effects of Diffusion-kinetics Parameters to the Comprehensive Combustion Simulation

Computational simulation of smoke temperature diffusing in high-rise building fire

Experimental and Numerical Study of Smoke Plumes in Stable Thermally Stratified Environments

Numerical Investigation on Heat and Mass Transfer of Volatile Flammable Gases Within the Nuclear Reactor Containment

Numerical Investigation on Smoke Movement in a Large Space Building under Fire Scenarios

Numerical Simulation on Smoke Temperature Distribution in a Large Indoor Pedestrian Street Fire

The Effects of Differential Diffusion on Turbulent Non-Premixed Flames LO2/CH4 under Transcritical Conditions Using Large-Eddy Simulation