Abstract:The metallurgical properties of blast furnace slag changed when high alumina iron ore was used extensively due to the resulting changes of the molten slag microstructure. In the study, based on typical CaO–MgO–SiO2–Al2O3 slag systems with different w(Al2O3) content, molecular dynamics simulation was used to calculate the microstructural properties of particles in the high-temperature slag system, such as bond length, partial radial distribution function, coordination numbers, and diffusion coefficient. In addition, X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, and 27Al solid-state magic angle spinning nuclear magnetic resonance (27Al SS MAS NMR) were used to detect and analyze the samples. The comprehensive calculations and experimental results show that increasing w(Al2O3) can enhance the structural stability of each ion pair, and the strength of the structural stability is such that Si–O > Al–O > Mg–O > Ca–O. The self-diffusion coefficients are as follows: Mg2+ > Ca2+ > Al3+ > Si4+, which leads to the transformation of the [SiO4]4−(Q0), [Si2O7]6−(Q1) and [Si2O6]4−(Q2) structural units to [Si2O5]2−(Q3). The degree of polymerization of slag increased as well as the stability of the structural units. Moreover, the coordination of Al will change from the [AlO6]9−octahedral structure of six-coordinated Al to the [AlO5]7−pentahedral structure of five-coordinated Al and the [AlO4]5−tetrahedral structure of four-coordinated Al. It was also found that the content of non-bridge oxygen in the whole slag system decreased continuously, leading to the increasing degree of polymerization of slag, and the experimental results were consistent with the molecular dynamics calculation.

The Effect of Ultrasonic Treatment on Alumina Leaching from Calcium Aluminate Slag

Effect of Adding Alum Sludge from Water Treatment Plant on Sewage Sludge Dewatering

Effect of calcium/aluminium ratio on MgO containing calcium aluminate slags

Effect of Na2O on alumina leaching property and phase transformation of MgO-containing calcium aluminate slags

Effects of Sintering Process Parameters on Physicochemical Properties of Calcium Aluminate Slag System

Effect of Al2O3 on the Molten Slag Microstructure Information by Molecular Dynamics Simulation and Experimental Analysis

Effect of physical properties of sodium aluminate solution on ultrasonic cavitation and intensification during precipitaiton process

Influence study on blast furnace cooling water quality by ultrasonication treatment

Effect of ultrasound on precipitation from super caustic aluminate solution of the bayer process

Effect of Na2o on Dissolution Rate of Alumina in Cao-Al2o3-Mgo-Sio2 Slag

Effect of Physical Properties of Sodium Aluminate Solution on Ultrasonic Cavitation and Enhancement During Precipitation Process

Effect of Mass Fraction of CeO2 on Leaching Resistance of Sodium Aluminosilicate Glass

Secondary Reaction Mechanism of Leaching Process of Calcium Aluminate Slag

Effect of Raw Material Mixture Ratio on Leaching and Self-disintegrating Behavior of Calcium Aluminate Slag

Alumina leaching properties of calcium sulphoaluminate

Degassing Effect of Ultrasonic Vibration in Molten Melt and Semi-Solid Slurry of Al-Si Alloys

Effect of Ultrasonic Treatment on Characteristics of Waste Activated Sludge

Effect of B2O3 on the structure and properties of aluminate slag

Study on ultrasonic leaching and recovery of fluoride from spent cathode carbon of aluminum electrolysis

Effect of Al2O3 on the Melting, Viscosity, and Phosphorus Distribution of CaO-SiO2-Fe2O3-P2O5 Slag System

Study on ultrasoic effects on sodium aluminate solution by Raman spectrum