Abstract:Composite ceramics of 0.7BaO center dot 0.3SrO center dot(I-gamma)TiO2 center dot gamma Nb2O5 (BSTN) with coexistence of barium strontium titanate, Ba1-xSrxTiO3 (BST), and strontium barium mobate, SrxBa1-xNb2O6 (SBN) phases were successfully prepared in situ by controlling excess components according to a specially designed formula of 0.7BaO center dot 0.3SrO center dot(1-gamma)TiO2 center dot gamma Nb2O5 and by using a traditional ceramic process. X-ray diffractometry (XRD), scanning electron microscopy (SEM) and energy dispersion spectrometer (EDS) were used to characterize the phase composition, morphology and the micro-area chemical composition of the composite ceramics. The results showed that the SBN tungsten bronze phase appeared and coexisted stably with the BST perovskite phase when the excess content of Nb2O5 was > 6mol%, whereas the BST perovsklite phase formed and coexisted stably with the SBN tungsten bronze phase when the excess content of TiO2 was > 5.3mol%. In the ease of the two phases being equivalent to each other in BSTN composite ceramics, Nb2O5 was hard to be resolved into the perovskite phase, however, a few of TiO2 was easy to be resolved in the tungsten bronze phase. The microstructure of the composite ceramics were consisted of two kinds of grains. The smaller polygonal grains were belonged to the BST phase, and the larger ones to the SBN phase. The coexistence of the two phases inhibited the growth of the BST crystal. The density of microstructure of the composite ceramic was higher than that of both the pure BST and SBN calcined at the same temperature for the same time.

Preparation of Barium Strontium Titanate Nanopowders by a Sol-Gel Hydrothermal Synthesis Method

Composition and shape control of single-crystalline Ba1-xSrxTiO3 (x=0-1) nanocrystals via a solvothermal route

Synthesis of barium strontium titanate nanopowders by microwave hydrothermal method

Synthesis and characterization of nanocrystalline barium strontium titanate powder by a modified sol-gel processing

Preparation of Barium Strontium Titanate Thin Films by Sol-Gel Technique

Preparation of Ba0.7Sr0.3TiO3 Powders by Means of Hydrothermal Process

Preparation of barium strontium titanate powders with Sol-Gel process

Study on Ba_1-xSr_xTiO_3(BST)Powders Prepared by Sol-Gel Methods

Hydrothermal Treatment of Barium Strontium Titanate (BST) Powders Obtained by Solution- Precipitation Method

Preparation of Ba0.6Sr0.4 TiO3 Powders by Hydrothermal Method

In situ Preparation of BST(Nb)/SBN(Ti) Composites

Microstructure and properties of barium strontium titanate fine powders synthesized by sol-gel method

Synthesis of Highly Dispersed Barium Titanate Nanoparticles by a Novel Solvothermal Method

Room-Temperature Synthesis of BaTiO<sub>3</sub>Nanoparticles in Large Batches

Preparation of Ba1-xSrxTiO3 by the sol-gel assisted solid phase method: Study on its formation mechanism and photocatalytic hydrogen production performance

Fabrication of (ba,sr)tio3 Thin Films by Hydrothermal Crystallization of Sol-Gel Precursor

Low Temperature Preparation of Baxsr1-Xtio3 Thin Films Prepared by Sol-Gel-Hydrothermal Method

Microwave-hydrothermal synthesis of barium strontium titanate nanoparticles

A novel sol-gel route to prepare barium strontium titanate (BST) thin films

Structure and Properties of Barium Strontium Titanate Nanoparticles Synthesized by A Hydrothermal Method

Microstructure and Fabrication of Barium Strontium Titanate(BST) Thin Films Basing a Novel Sol-gel Route