Abstract:Ultrasonic fatigue testing is a key technology that is more efficient and energy saving compared to conventional fatigue testing. In order to investigate the behavior of metallic materials at ultra-high frequencies and to verify the validity of ultrasonic fatigue test results, this paper builds a test apparatus that can be used to conduct ultrasonic fatigue tests, and this paper proposes a complete procedure from theoretical analysis to the investigation of test laws for 20 kHz tensile and the compression test. Firstly, the initial sizes of the sample are calculated with an analytical method, then the three-dimensional model is simulated and optimized with finite element software, and the optimum result for the sample size is then obtained according to the sensitivity of the sample size to the effect of frequency. The next step is to analyze the influenced trend of the sample size, including L1, L2, L3, R1 and R2, on the resonant frequency and maximum stress of the sample. According to the optimized results, the sample was processed, and an ultrasonic fatigue test was carried out to ensure the sample fatigue fracture finally occurred. Finally, the S-N curve of the material was plotted based on the data recorded in the test and compared with the conventional fatigue life curve to verify the feasibility of the ultrasonic fatigue test device and test method. The fracture of the sample was observed using an optical microscope, and its macroscopic fracture morphology was analyzed. The fracture morphology of the sample can be divided into three typical zones: the fatigue crack source zone, the extension zone and the transient zone, where the fatigue cracks all originate from on the surface of the sample. The results demonstrate the validity of the ultrasonic fatigue test results and provide new ideas for the design and optimization of ultrasonic fatigue samples and shorter processing times, providing a reference for subsequent ultrasonic fatigue tests on typical materials.

Anti-fatigue design of ultrasonic bone cutter based on finite element method

Study on Ultra‐low Cycle Fatigue Fracture of Thick‐walled Steel Bridge Piers

Depth-sensing Indentation Measurement and Finite Element Analysis of Residual Stress Field Near Fatigue Crack Tip

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

Finite Element Simulation of High-Speed Cutting

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

Design for reliability of ultrasonic bone knife

Research on ultrasonic bone cutting mechanism based on extended finite element method

Finite element analysis of temperature effect and crack-control measures for ultra-long concrete structures

Experimental and Finite Element Analysis of Force and Temperature in Ultrasonic Vibration Assisted Bone Cutting

Finite Element Analysis and Structural Improvement on Jaw Crusher Frame with Compound Pendulum

Quantitative Study of High-Frequency Fatigue Hole-Edge Stresses in Nickel-Based Single-Crystal Superalloy

Design and Performance Study of an Ultrasonic Bone Scalpel with Composite Horn Structure

Fatigue life estimation of metal materials based on finite element analysis

Design Theory and Experimental Research of Ultrasonic Fatigue Test

Numerical Failure Analysis and Fatigue Life Prediction of Shield Machine Cutterhead

Finite Element Analysis of High Speed Cutting Tool

Crack propagation determined by energy release rate in cortical bone ultrasonic vibration assisted cutting

Influence of Mechanical Factors on the Cutting Performance of an Ultrasonic Bone Scalpel

Structural Fatigue Crack Propagation Simulation and Life Prediction Based on Improved XFEM-VCCT

Computational intelligent optimization approach based on Particle Swarm Optimization and Extended Finite Element Method for high-cycle fatigue life extension