Abstract:Dimethyl ether (DME) is a highly reactive diesel substitute that can be used as a pilot fuel to ignite low- reactivity methane (CH4) in heavy-duty engines. To optimize the efficiency and emissions of CH4/DME dual-fuel engines, it is crucial to study the fundamental combustion characteristics of DME mixed with methane. This study focuses on the influence of CH4 addition on the low-temperature oxidation (LTO) preparation stage and the thermal ignition (TI) preparation stage of DME in the two-stage ignition process, as these two stages respectively control the ignition delay of the first and second stages. The comparison is made between pure DME and a 50% CH4 and 50% DME blended fuel, operating under thermodynamic conditions representing the engine in- cylinder environment at 30 atm pressure, 650K temperature, and a stoichiometric equivalence ratio. The results show that the addition of methane hardly affects the control mechanism of the two-stage ignition of DME. Specifically, the LTO preparation stage is still promoted by the increase in OH radicals in the DME’s low-temperature oxygenation pathways to form KET, and the second stage is still controlled by the H2O2 loop mechanism. The kinetic analysis also reveals that methane addition can compete for some of the OH radicals in the LTO preparation stage, which has a suppressing effect on ignition. However, in the TI preparation stage, methane can promote the loop reaction of OH→HO2→H2O2→OH and promote ignition. For the operating conditions studied here, although methane consumes a total of 7.24% prior to thermal ignition, it only consumes 0.63% of the total amount in the LTO preparation stage and 1.81% of the total amount in the TI preparation stage. This indicates that methane is mainly consumed in the LTO stage, accounting for 65% of the total methane consumption amount. It can be concluded that the kinetic effect of methane has a relatively small impact on the ignition delay of the DME, at least for the conditions investigated here. In other words, the dilution and thermal effects caused by adding methane are the main reasons for the prolonged time of LTO/TI preparation. Overall, more fundamental research is warranted to understand the role of methane in the two-stage ignition process of DME, which could facilitate the development of CH4/DME dual-fuel engines.

Experimental and Kinetic Study on Ignition Delay Times of Dimethyl Ether at High Temperatures

Experimental and numerical study on the ignition delay times of dimethyl ether/propane mixtures in O2/CO2 atmospheres

Experimental and computational study of nonpremixed ignition of dimethyl ether in counterflow

The Effect of Methane Addition on the Low-Temperature Oxidation Preparation and the Thermal Ignition Preparation of Dimethyl Ether under Representative Engine In-Cylinder Thermal Conditions

Stage-wise Kinetic Analysis of Ammonia Addition Effects on Two-Stage Ignition in Dimethyl Ether

A shock tube study of the ignition delay time of DME/ammonia mixtures: Effect of fuel blending from high temperatures to the NTC regime

Investigation of the Effect of Ammonia Addition on the Two-Stage Ignition Process of Dimethyl Ether Based on Chemical Kinetic Analysis

High Temperature Ignition and Combustion Enhancement by Dimethyl Ether Addition to Methane–air Mixtures

Experimental Investigation of Low-Temperature Autoignition in Turbulent Premixed Swirling Flames

An Experimental Investigation of Ethylene/o2/diluent Mixtures: Laminar Flame Speeds with Preheat and Ignition Delays at High Pressures

Experimental and modeling study of the ignition kinetics of dimethyl carbonate

Experimental and modeling study on ignition delays of lean mixtures of methane, hydrogen, oxygen, and argon at elevated pressures

Ignition Delay Times of Ethane under O2/CO2 Atmosphere at Different Pressures by Shock Tube and Simulation Methods

Ignition Characteristics of Dual-Fuel Methane-N-hexane-oxygen-diluent Mixtures in a Rapid Compression Machine and a Shock Tube

Shock tube and modeling study on the ignition delay times of ammonia/dimethoxymethane at high temperature

An experimental and kinetic modeling study on the ignition characteristics of ammonia/ethanol at high temperatures

Experiments and Modeling of the Autoignition of Methylcyclohexane at High Pressure

Composition of Reaction Intermediates for Stoichiometric and Fuel-Rich Dimethyl Ether Flames: Flame-Sampling Mass Spectrometry and Modeling Studies

Experiments and Modeling of the Autoignition of Methyl-Cyclohexane at High Pressure

Shock Tube Study of Ignition-Delay Measurements and Kinetic Mechanism Research for Syngas

Numerical Study on Three-Stage Ignition of Dimethyl Ether by Hot Air under Engine-Relevant Conditions