Abstract:Dendrites form on the surface of metal electrodes as a battery undergoes repeated charging and discharging. The formation of dendrites not only affects the electrochemical performances of a battery but may also cause internal short-circuiting and thermal runaway events. Hence, there is a clear need to understand the formation mechanisms and growth kinetics of dendrites. Currently available technologies such as (in-situ) X-ray computed tomography and scanning electron microscopy can be used in a laboratory environment to study dendrite formation. However, they are often prohibitively expensive or unsuitable for long-term, large-scale, and in-operando monitoring. In this study we present an ultrasound-based technique which is cheap, with potential to scale up, and suitable in both laboratory and industrial environments. Different from conventional ultrasonic approaches which excite ultrasonic waves that propagating through layers of cathode, anode and electrolyte, the method presented in this study utilises miniature transducers which excite fundamental shear-horizontal (SH0*) guided ultrasonic waves that propagate along the cathode and anode. Hence, the presented method can individually monitor the condition of multiple electrodes which may be undergoing different ion-insertion mechanisms. A proof-of-concept study was performed on a symmetric aqueous zinc ion cell to explore the sensitivity of SH0* mode guided ultrasonic waves to zinc metal plating/stripping and dendrite formation at the electrode-electrolyte interface. We observed that the attenuation and velocity of waves show cyclical variations when the cell was in a chronopotentiometric cycling test. Variations of wave attenuation and velocity on the opposing working and counter electrode are observed to be in the opposite senses and the increasing/decreasing trends depend on the states (i.e., charging/discharging) of the cell. The cyclical variations of the ultrasound properties are only partially reversible and a monotonic drift can be observed which increases with increasing number of cycles. Coupling the ultrasonic measurements with images acquired by an optical microscope, clear correlations can be observed between changes in ultrasonic wave properties and zinc dendrite thickness. The partially reversible cyclical variations can be attributed to zinc plating/stripping that occur at the electrode-electrolyte interface. The irreversible, monotonic drifting can be attributed to the growth of zinc dendrites on the electrode surface. Hence, these findings demonstrate that the SH0* mode guided ultrasonic waves can offer valuable insights on physical changes at the electrode-electrolyte interface. It is therefore possible to quantitatively model and predict dendrite growth based on ultrasonic measurements. In conclusion, we believe the presented method can inspire more quantitative research on dendrite formation and in-operando monitoring of battery health. Figure 1

Continuous Monitoring of Acid Stratification During Charge Discharge by Holographic Laser Interferometry

Time-frequency Analysis of the Spatial Distribution for Li+concentration in the Electrolyte Throughout the Full Battery

In Situ Visualization of Ion Transport Processes in Aqueous Batteries

Online Digital Holographic Method for Interface Reaction Monitoring in Lithium-Ion Batteries

Diffusion-Induced Transient Stresses in Li-Battery Electrodes Imaged by Electrochemical Quartz Crystal Microbalance with Dissipation Monitoring and Environmental Scanning Electron Microscopy

Revealing Relationship Between in Situ Impedance and Lithium Plating Onset Based on Lithium–Graphite Half-Cells

Operando monitoring the lithium spatial distribution of lithium metal anodes

Direct Visualization of Dynamic Mobility of Li 2 O 2 in Li–O 2 Batteries: A Differential Interference Microscopy Study

Operando monitoring of strain field distribution in lithium battery anode via ultra-high spatial resolution optical frequency domain reflectometer

in situ Monitoring of Lithium Electrodeposition using Transient Grating Spectroscopy

Application of Alternating Current Scanning Electrochemical Microscopy in Lithium‐Ion Batteries: Local Visualization of the Electrode Surface

Non-destructive monitoring of charge-discharge cycles on lithium ion batteries using ⁷Li stray-field imaging

In Situ Volume Change Studies of Lithium Metal Electrode under Different Pressure

(Digital Presentation) Monitoring Dendrite Growth in Aqueous Zinc Ion Batteries with Guided Ultrasonic Waves

Using optical absorption to measure the state of charge of lead-acid batteries

Visualization of Electrolyte Reaction Field Near the Negative Electrode of a Lead Acid Battery by Means of Amplitude/Frequency Modulation Atomic Force Microscopy

Flow Cell for Simultaneous In Situ Analysis of Local Electrolyte Distribution and Porous Morphology within the Negative Electrode in a Lead-Acid Battery

The Entanglement of Li Capping and Deposition: An Operando Optical Microscopy Study

Guided waves propagation in lithium-ion batteries: Theoretical modeling and experimental analysis

In Situ, Time-Resolved Raman Spectromicrotopography of an Operating Lithium-Ion Battery

In Situ Visualization of Electrochemical Processes in Solid-State Lithium Batteries