Abstract:This paper presents a 27.7-31.2 GHz highly integrated 8-element 4-beam transmitter front end in 65-nm CMOS for phased-array applications. The proposed hybrid variable-gain amplifier (VGA) combines digital common-source (CS) VGA and analog Gilbert-cell-based VGA to realize a large tuning range and high resolution simultaneously. Furthermore, the proposed VGA scheme also integrates with an active combining network to implement a compact multi-beam structure. In the vector-modulation-based phase shifter (PS), low/high pass lumped delay lines are inserted between CS transistors and common-gate (CG) transistors to form I/Q signals which drive four pairs of Gilbert-cell based G(m)-arrays for different phase states. In addition, the output element leverages a symmetrical transformer-based Doherty power amplifier (PA) and an analog adaptive bias to improve the power-back-off (PBO) efficiency with a high peak-to-average-ratio (PAPR) modulation signal. With a 1.1-V supply voltage, this front end achieves a saturated output power (P-sat) of 19.2 dBm with a 20.5% channel efficiency and a 1-dB compression point (OP1dB) of 18.2 dBm. The measured maximum drain efficiency (DE) is 40.8% and 6-dB PBO DE is 28%. Compared with class-B/A PAs, the DE is improved by 40%/180%. The proposed hybrid VGA achieves a 27-dB tuning range and a 0.25-dB gain step with 0.26 dB/1.9 degrees RMS gain/phase errors. The active PS implements 6-bit 360 degrees phase shifting with 0.25 dB/2.5. RMS gain/phase errors.

A Ku-Band 8-Element Phased-Array Receiver in 0.18-mu m CMOS Technology

A Ku-Band 8-Element Phased-Array Receiver in O.18-μm CMOS Technology

A C-Band Compact High-Linearity Multibeam Phased-Array Receiver With Merged Gain-Programmable Phase Shifter Technique

A 4-Element 7.5-9 GHz Phased Array Receiver with 8 Simultaneously Reconfigurable Beams in 65 Nm CMOS Technology

A Four-Element 7.5–9-Ghz Phased-Array Receiver with 1–8 Simultaneously Reconfigurable Beams in 65-Nm CMOS

A K-Band 4-Element 8-Beam Phased-Array Receiver with Hybrid Vector Interpolation and Impedance-Adapted Multibeam Combining Techniques for Satellite Communications

A Compact Ka-Band Eight-Element Four-Beam Receiver for Low-Earth-Orbit Satellite Communications in 65-Nm CMOS

A $C$ -Band Slat-Type Phased-Array Receiver with Co-Aperture Concurrent Eight Beams

A Ka-Band 64-Element Four-Beam Phased Array Receiver with Inter-Beam Interference Cancellation

A K-Band Eight-Element Dual-Beam Receiver with Current-Sharing-Based Low-Power Technique for LEO SATCOM in 65-Nm CMOS

An 800-Ps Origami True-Time-Delay-Based CMOS Receiver Front End for 6.5–9-Ghz Phased Arrays

A Ka-band 8-Element 4-Beam Transmitter Front End with Hybrid VGA and Symmetrical Transformer-based Doherty PA

A CMOS Ku-band Receiver Chain for Phased Array System

Robustness‐oriented P‐band Phased Array Radar Front‐end with High Phase and Gain Resolution in 0.18 BiCMOS

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A Ku Band 4-Element Phased Array Transceiver in 180 Nm CMOS

A Ku-Band 8-Element Phased-Array Transmitter with Built-in-Self-Test Capability

A Temperature-Compensated Ku-Band Four-Beam Phased-Array Receiver with Low Attenuation and Relative Phase Variations

A CMOS 4-Element Ku-Band Phased-Array Transceiver

A Fully Integrated X-Band Phased-Array Transceiver in 0.13-Μm CMOS Technology

An 8-Channel Ku-Band Phased-Array Transmitter