Abstract:Response characteristics of the atomic absorption spectrometric detector and dispersion contributions of individual components of the flow injection atomic absorption spectrometry (Fl-AAS) system were studied using samples of less than 100-mu-l. The dispersion coefficient D, half steady-state time t1/2 and half steady-state volume V1/2 were used for evaluation. The transport conduits and sample loops in previously reported manifolds were found to be the main sources of sample dispersion. The detector studied had a t1/2 response time of 0.20 s, which was almost independent of the sample introduction rate. Dispersion effects in the nebulizer-burner system, which influence the response kinetics of the detector, generally showed a very limited contribution of the over-all dispersion of the injected samples. Knotted sample loops, and short transport conduits of 0.35 mm i.d., were used in an improved Fl sample introduction manifold in order to limit dispersion. By injecting 45 and 65-mu-l samples, 90 and 98%, respectively, of the steady-state signal from conventional sample aspiration were achieved. The precision and detection limits obtained by peak height measurement at an optimized carrier flow-rate of 4.2 ml min-1 were comparable to conventional methods and were better than peak area measurements by a factor of 2. An absolute detection limit of 3 ng was obtained for lead in the peak height mode with a 35-mu-l sample, compared with 80 ng by conventional steady-state measurements. Tolerance of a high content of dissolved solids in samples was improved and demonstrated by repeated determinations (65-mu-l injections) of 10-mu-g ml-1 of Pb in saturated lithium borate solution at 360 samples h-1 for 1 h with 0.9% relative standard deviation (RSD), and in 30% m/v NaCI solution at 180 samples h-1 with 2% RSD.

Flame Furnace Atomic Absorption Spectrometry: A Review

Comparison of Tungsten Coil Electrothermal Vaporization and Thermospray Sample Introduction Methods for Flame Furnace Atomic Absorption Spectrometry.

Highly Sensitive Pneumatic Nebulization Flame Furnace Atomic Absorption Spectrometry: Complete Sample Aerosol Introduction and On-Line Preconcentration of Cadmium by Atom Trap

A Compact Electrothermal-Flame Tandem Atomizer for Highly Sensitive Atomic Fluorescence Spectrometry

Modern instrumentation and practical application of flame atomic emission spectrometry

Investigation of Thermospray Flame Furnace Atomic Absorption Spectrometric Determination of Cadmium Combined with Ultrasound-Assisted Dispersive Liquid-Liquid Microextraction

Flow Injection Atomic Absorption Spectrometry

Improved Performance of On-line Atom Trapping in Flame Furnace Atomic Absorption Spectrometry by Chemical Vapor Generation: Determination of Cadmium in High-Salinity Water Samples

Flow injection on-line dilution for flame atomic absorption spectrometry by micro-sample introduction and dispersion using syringe pumps

Contribution of System Components to Dispersion in the Analysis of Microvolume Samples by Flow-Injection Flame Atomic-Absorption Spectrometry

Atomic fluorescence spectrometry: A review of advances in instrumentation and novel applications

Measurement of Flame Temperature Using Simultaneous Dual-line Atomic Absorption of Two Elements

Sensitive Determination of Lead by Flame Atomic Absorption Spectrometry Improved with Branched Capillary As Hydride Generator and Without Phase Separation

Field instrumentation in atomic spectroscopy

Critical Evaluation of the Efficiency and Synergistic Effects of Flow Injection Techniques for Sensitivity Enhancement in Flame Atomic Absorption Spectrometry

Microanalysis for Flame Atomic Absorption Spectroscopyin Determination of High Content Sodium

Determination of Se, Pb, and Sb by Atomic Fluorescence Spectrometry Using a New Flameless, Dielectric Barrier Discharge Atomizer

Investigation of Dispersive Solid-Phase Extraction Combined with Slurry Sampling Thermospray Flame Furnace Atomic Absorption Spectrometry for the Determination of Cadmium

Use of a furnace with a graphite filter for electrothermal atomic absorption spectrometry

Determination of Bioavailable Cadmium in Environmental Samples by Flame Atomic Absorption Spectrometry

Determination of Sr Content in Mg-Sr Alloys Using Faas