Abstract:Magnesium borate whisker (Mg2B2O5 w) reinforced Mg matrix composite was fabricated by vacuum-gas pressure infiltration process. The Mg2B2O5 w preforms forming process was determined. The Mg2B2O5 whiskers were fabricated into a preform by wet forming method without any binder. The Vacuum-Gas Pressure Infiltration process and parameters are also developed. The micrographs revealed reasonably uniform distribution and random orientation of the whiskers in the as-cast Mg2B2O5 w/AZ91D composite and the composites were without pores defect. The phases were analyzed by XRD patterns for the as-received whiskers, the whiskers sintered at 1 000 degrees C for 3 h and the as-cast composite, respectively. Then, the microstructure evolution of the composite was investigated when the composite was heat-treated. Meanwhile, the relationships between microstructure and micro-hardness of the alloy heat-treated were also studied. The heat-treatment condition were solution at 415 degrees C for 8 and 24 h, respectively, aging treatment at 200 degrees C for 8, 12, 16, 20 and 24 h, respectively and solution at 415 degrees C for 8 or 24 h and subsequent aging treated for 8, 12, 16, 20, 24 h, respectively. The phases were analyzed by XRD patterns for the composites after different heat treated process. The results of XRD patterns were shown to be in good agreement with the microstructures evolution of the composites. The results showed that the micro-hardness of the solution treated composites is decreased due to resolution of eutectic phase, whereas the micro-hardness of the aged composites was increased gradually and the peak hardness is reached to 201 HV in the composite aged for 16 hours. Solution treatment at 415 degrees C for 24 h, the beta-Mg17, Al12 phase is dissolved in the alpha-Mg phase to form oversaturated solid-solution in the composite and then the diffusive beta phase precipitates after subsequent aging treatment at 200 degrees C for 8 h; hence the micro-hardness of the composite was increased 30%. However, as the aging time increased to 24 h, the hardness of the composite was reduced to 183 HV because the beta-Mg17 Al12 phase precipitate changed from continuous fine platelets to discontinuous coarse platelets. It was concluded that the process of solution at 415 degrees C for 24 h and subsequent aging treatment at 200 degrees C for 8 h was the best process for the composite.

Aging Behaviors of Alumina Borate Whisker Reinforced AC8A-AI Composite

The Effects of Ageing and Whisker-Orientation on Wear Behaviour of SiCwAl Composites under Unlubricated Sliding Friction

Effect of the interfacial reaction of aluminum and yttrium oxide on aging behavior of aluminum–magnesium–silicon alloy reinforced with yttrium oxide modified sub-micron alumina

Two-stage aging treatment to accelerate aging kinetics without impairing strength in B4C/7A04Al composite

Slurry erosion resistance of Al18B4O33 whisker-reinforced AC4C Al alloy matrix composites

The solid particle erosion behavior of Al18B4O33 whisker-reinforced AC4C al alloy matrix composites

Spectroscopic Characterization and Properties of Mg2B2O5w/AZ91D Magnesium Composites

Silicon Nitride Whisker-Reinforced Aluminum Matrix Composites: Twinning and Precipitation Behavior

Effect of Interfacial Reactions on Solid Erosion of Al_(18) B_4O_(33) Whisker-Reinforced AC4C Al Alloy Matrix Composites

Effect of interfacial reactions on solid erosion of Al18B4O33 whisker-reinforced AC4C Al alloy matrix composites

The Influence of TiB2 Particles on the Artificial Aging Behavior of TiB2/Al–5Cu Composite

Influence of particulate B4C with high weight fraction on microstructure and mechanical behavior of an Al-based metal matrix composite

Effect of Aging Treatment on the Mechanical Properties of 45 vol.% SiCp/6061Al Composite

Microstructural investigation of the aging behavior of $(3Y-TZP)-Al_2O_3$ composites

Microstructure evolution and tensile behavior of MgAlB4w/Al composites at high temperatures

Microstructures, mechanical properties, and aging behavior of hybrid-sized TiB2 particulate-reinforced 2219 aluminum matrix composites

Effect of aging treatment on microstructure and mechanical properties of Al matrix composite reinforced by in-situ intragranular Al 2 O 3

In situ processing and aging behaviour of an aluminium/Al2O3 composite

Rare-earth modification of sub-micron Al2O3 particle surface and its effect on the aging behavior of 6061Al composite

Precipitates Evolution During Isothermal Aging and Its Effect on Tensile Properties for an AFA Alloy Containing W and B Elements

The aging behavior, microstructure and mechanical properties of AlN/AZ91 composite