Abstract:This study presents the numerical analysis of single-phase forced convection heat transfer and pressure drop during internal flow in a shallow, rectangular sandwich-like copper channel heated from both the top and the bottom. Simulations were conducted using a commercial finite volume solver that solves governing continuity, momentum, and energy equations simultaneously. The bottom side of the channel was considered with arrays of rectangular miniature-pin fins. The miniature-pin fin geometry was modeled in a staggered configuration with tip clearance from the opposite surface while the orientation of the fins was directed parallel to the flow direction of the working fluid. Water was used as a working fluid with a fully developed velocity profile at the channel entry. Simulations were carried out for varying inlet temperatures and mass flow rates. All calculations were performed with the RNG k-ε model to model complex turbulent flows appropriately. Grid independence and validation analyses were also conducted. With the validated model, additional analyses were performed for 0, 0.1, 0.3, 0.6, and 1 mm tip clearances, and correlations were proposed after performing regression analyses for the friction factor and heat transfer coefficient. The calculations revealed that in contrast to a straight (nonfinned) surface, up to 220% larger heat transfer coefficients could be obtained for the finned surfaces under comparable operating conditions. It was also shown that tip clearance in turbulent flow affects heat transfer negatively. With increasing clearance, the Nusselt number decreased; in other words, heat transfer worsened. On the other hand, the use of miniature-pin fins led to a rise in the pressure drop over the entire heated length. For the Reynolds number spectrum of 4000–20000, the ratio of the friction coefficient of the finned surface to the friction coefficient of the nonfinned surface varied from 6 to 5 while with a further reduction in pressure loss a value of approximately 4 could be obtained for larger tip clearances. Hence, with larger tip clearances, the friction factor decreased, reflecting the abatement of pressure loss.

Investigation of Turbulent Flow and Heat Transfer in Periodic Wavy Channel of Internally Finned Tube with Blocked Core Tube

Simulation And Analysis On Heat Transfer In Laminar Oscillatory Flow In-Tube

Detailed Heat Transfer Measurements of Curved Fin Channels

Flow and Heat Transfer Analysis of Perforated Fin in Compact Heat Exchanger

Forced Heat Convection of Wavy Fin Channel

Numerical analysis of heat transfer and fluid flow in a three-dimensional wavy-fin and tube heat exchanger

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Experimental and numerical investigation on flow and heat transfer characteristics of a multi-waves internally spiral finned tube

Experimental study on single-phase heat transfer performance of internal helically finned tubes covering low Reynolds number in turbulent flow

Flow and Heat Transfer Characteristics of a Double-Tube Structure Internal Finned Tube with Blossom Shape Internal Fins

Complex Turbulent Flow and Heat Transfer Characteristics of Tubes with Internal Longitudinal Plate-Rectangle Fins in EGR Cooler

Numerical Investigation of Fluid Flow and Heat Transfer in High-Temperature Wavy Microchannels with Different Shaped Fins Cooled by Liquid Metal

Numerical Study on Heat Transfer Performance of a New-proposed Pin-fin in an Internal Channel

Numerical Investigation of Thermo-Flow Characteristics of Tubes with Transverse Micro-Fins

Numerical study of the intensification of single-phase heat transfer in a sandwich-like channel using staggered miniature-pin fins

Numerical Simulation of Heat Transfer and Pressure Drop Characteristics of Internal Microfin Tubes

Numerical Study of Flow and Heat Transfer Enhancement by Using Delta Winglets in a Triangular Wavy Fin-and-Tube Heat Exchanger

Experimental and numerical investigation on the flow and heat transfer characteristics of the tube with an integrated internal longitudinal fin

A numerical study on the flow over a novel tube for heat-transfer enhancement with a linear Eddy-viscosity model

Analysis of Local Heat Transfer Characteristics of Water and Steam in Helically-Coiled Tube

Numerical Investigation of Fluid Flow and Heat Transfer in Mini-Fin Structures