Abstract:Recently, more attentions have been paid to natural polymer-based flocculants in water treatment, since they are believed to be low-cost, nontoxic, and environmentally friendly materials. In this work, strong cationic chitosan-based graft copolymer flocculants (3-chloro-2-hydroxypropyl trimethyl ammonium chloride (CTA) modified chitosan-graft-polyacrylamide, denoted as chitosan-CTA-g-PAM) have been prepared, and their flocculating properties were studied systematically, both at the laboratory scale and at the pilot scale. In laboratory scale, a kaolin suspension was employed as synthetic wastewater. The effects of dosage, temperature, and original turbidity of untreated wastewater were investigated, respectively. Moreover, in pilot scale, the raw water from the Zhenjiang part of the Yangtse River in China was used as wastewater. The influences of three external factors-dosage, sedimentation time, and mechanical mixing rate on the flocculating performances have been studied by orthogonal testing, respectively. The experimental results in pilot scale were fairly consistent with those from the beaker experiment in laboratory scale. In comparison with polyferric sulfate, which is the flocculant currently used by the Zhenjiang Water Supply Company, chitosan-CTA-g-PAM showed better flocculating properties. Meanwhile, the effect of the degree of substitution of CTA on the flocculating properties has been also studied, both at the laboratory scale and at the pilot scale. It was indicated that chitosan-CTA-g-PAM with higher cationic degree had better flocculating performances, which was also confirmed by the flocculation kinetics analysis. Furthermore, the flocculation mechanisms of chitosan-CTA-g-PAM have been discussed in detail. Above all, the flocculating experiments in laboratory and pilot scales both indicated that chitosan-CTA-g-PAM showed good flocculating performances in water treatment.

Effects of compound flocculants on civil sludge dewatering

Preparation and Application of Slag Compound Flocculant

A Quality Improvement Initiative Reduces 30-Day Rate of Readmission for Patients With Cirrhosis.

Combined Use of Inorganic Coagulants and Cationic Polyacrylamide for Enhancing Dewaterability of Sewage Sludge

Influence of composite flocculant FeCl3-APAM on vacuum drainage of river-dredged sludge

Preparation of Strong Cationic Chitosan-graft-Polyacrylamide Flocculants and Their Flocculating Properties

Application of Flocculation Combined with Vacuum Preloading to Reduce River-Dredged Sludge

Sludge Dewaterability of a Starch-Based Flocculant and Its Combined Usage with Ferric Chloride

The Flocculating Properties of Chitosan-Graft-Polyacrylamide Flocculants (Ii)-Test in Pilot Scale

Chitosan Modified Cationic Polyacrylamide Initiated by UV-H2O2 for Sludge Flocculation and New Insight on the Floc Characteristics Study

Vacuum Preloading and Electro-Osmosis Consolidation of Dredged Slurry Pre-Treated with Flocculants

Characterization and Sludge Dewaterability Evaluation of a Chitosan‐based Flocculant CMCTS‐g‐CPAM

Sludge Dewaterability with Combined Conditioning Using Fenton's Reagent and CPAM

Experimental investigation on sedimentation characteristics of coastal slurry by flocculation

Dewatering Characteristics of the Kaolin Slurry Treated by Single and Dual Polymer Flocculants

Characterization and coagulation–flocculation performance of a composite coagulant: poly-ferric-aluminum-silicate-sulfate

Screening on Complexation and Applicatiom of Compound Microbial Flocculant and Chemical Flocculant

Flocculation and dewatering of the Kaolin slurry treated by single- and dual-polymer flocculants

Effects of a New Synthetic Fe-PAM Flocculants on Filtration and Consolidation of Bentonite Slurry

Flocculant effects on fluidity and strength behavior of cemented dredged clay with high water content

A systematic investigation of peracetic acid oxidation and polymeric coagulants re-flocculation to enhance activated sludge dewatering: Multi-porous skeleton structures