Abstract:This study investigates the efficiencies and mechanisms of the catalytic degradation of polychlorinated dibenzo-p-dioxins and furans (PCDD/Fs) first, in simulated laboratory conditions and then, in a commercial municipal solid waste incineration (MSWI) plant. Five commercially available V2O5-WO3/TiO2 (VWTi) catalysts were tested. The degradation efficiency of PCDD/Fs in the simulated flue gas ranged 22.8-91.7% and was generally higher than that in the MSWI flue gas of 8.0-85.4%. The degradation efficiency of PCDD/Fs in the real flue gas of the MSWI plant was largely hindered by the complex composition of the flue gas, which could not be completely reproduced in the simulated laboratory conditions. Furthermore, the degradation of the higher chlorinated PCDD/Fs was easier compared to the lower chlorinated ones in the presence of the VWTi catalysts, which was primarily driven by the tendency of the higher chlorinated PCDD/Fs to be adsorbed on the surface of the catalyst and further destructed due to their lower vapor pressure. In addition, powdered catalysts should be preferred over the honeycomb shaped ones as they exposed higher PCDD/Fs degradation efficiencies under equal reaction conditions. The chemical composition and a range of the relevant to the study properties of the catalysts, such as surface area, crystallinity, oxidation ability, and surface acidity, were analyzed. The study ultimately supports the identification of the preferred characteristics of the VWTi catalysts for the most efficient degradation of toxic PCDD/Fs and elucidates the corresponding deactivation reasons of the catalysts.

Comparative Studies on Chemical Modification of Polytetrafluoroethylene Slurry in ETV-ICP-AES and ETAAS

Thermal Kinetics of PFAS and Precursors in Soil: Experiment and Surface Simulation in Temperature-Time Plane

Direct analysis of titanium dioxide solid powder by fluorination assisted electrothermal vaporization inductively coupled plasma atomic emission spectrometry

Experimental study on erosion wear behavior of PFA coated stainless steel tube

Comparative Analyses of Catalytic Degradation of PCDD/Fs in the Laboratory Vs. Industrial Conditions

Comparative analyses of catalytic degradation of PCDD/Fs in the laboratory vs. industrial conditions.

PTFE surface etching in the post-discharge of a RF scanning plasma torch: evidence of ejected fluorinated species

Modification of fluoropolymers by means of electron beam irradiation

Use of a furnace with a graphite filter for electrothermal atomic absorption spectrometry

Surface Modification of Poly(tetrafluoroethylene) Films Via Plasma Treatment and Graft Copolymerization of Acrylic Acid

Deposition of PTFE thin films by ion beam sputtering and a study of the ion bombardment effect

Etching Processes of Polytetrafluoroethylene Surfaces Exposed to He and He-O2 Atmospheric Post-discharges

XPS and FTIR Studies of Polytetrafluoroethylene Thin Films Obtained by Physical Methods

Evolutionary characteristics of infrared temperature field and micro analysis for Al/PTFE reactive materials in cook-off experiment

Influence of PTFE Dispersion in the Catalyst Layer of Porous Gas-Diffusion Electrodes for Phosphoric Acid Fuel Cells

The Properties Evaluation and Comparison for Modified PTFE Flexible Tubes

The tribological properties of PTFE filled with thermally treated nano-attapulgite

Investigation on the microstructural and mechanical properties of a Polytetrafluoroethylene thin film by radio frequency magnetron sputtering

Electron irradiation enhanced wear resistance and hardness of polytetrafluoroethylene (PTFE)

Study of the Surface-Modified Teflon/ceramics Complex Material Treated by Microwave Plasma with XPS Analysis

PLASMA TREATMENT OF POLYTETRAFLUOROETHYLENE Ⅲ.XPS CHARACTERIZATION OF THE TREATED SURFACE