Abstract:Optical fiber communication systems are going to adopt the use of advanced modulation formats. It is thus important to develop measurement techniques and solutions capable of quantifying such signals. Linear optical sampling is an effective technique to characterize the quality of an advanced modulation format for high-speed optical signal with high fidelity, while the passively mode-locked fiber laser is an enabling module to implement the linear optical sampling. In this paper, we obtain a trade-off relationship between the repetition rate of passively mode-locked fiber laser and the linewidth of high-speed signal under test, after the introduction of operation principle for linear optical sampling. It is found that, for the quadrature phase shift keying (QPSK) signal, when the ratio of the linewidth of the signal under test to the repetition rate of passively mode-locked fiber laser is less than 1.5 × 10?3, the linear optical sampling-induced impairments can be ignored when there occurs phase noise. Therefore, the phase estimation can be successfully made by using the Viterbi-Viterbi algorithm applied to the block of samples corresponding to the modulation format phase states. Next, we use an optical sampling pulse with a repetition rate of 95.984 MHz, and carry out the optical linear sampling to a 28 Gbaud QPSK signal with a linewidth of 100 kHz. The error vector magnitude (EVM) has long been a commonly used parameter for quantifying the quality of advanced modulation signals. Using the standard coherent detection algorithm, we can successfully recover the constellation with the error vector magnitude (EVM) error less than 1%. Theoretical investigations agree well with the experimental characterization. Such a conclusion is helpful to optimize the design of passively mode-locked fiber laser for optical sampling application.

Non-Synchronous Optical Sampling and Data-Pattern Recovery Using A Repetition-Rate-Tunable Carbon-Nanotube Pulsed Laser

Repetition Rate Optimization of Passively Mode-Locked Fiber Laser for High-Speed Linear Optical Sampling

All-Optical, Bit-Rate Tunable Clock Recovery For Nrz-Ask Signals

Software-synchronized all-optical sampling for fiber communication systems

Optimization of Linear Optical Sampling Analog Front-End and Test for 128 Gb/s Signals

Experimental Demonstration Of An All-Optical Clock And Data Recovery Technology For 10 Gb/S Nrz-Dpsk Signals

Tunable Compact Asynchronous Optical Sampling System Using Er-doped Fiber Laser

All-Optical Temporal Differentiation of Ultra-High-Speed Picosecond Pulses Based on Compact Silicon Microring Resonator

Integrated High-Repetition-Rate Optical Sampling Chip Exploiting Wavelength and Mode Multiplexing

Investigation on All-Optical Clock Recovery from RZ-Format Data at 64Gbit/s by Using a Two-Section Index-Coupled DFB Laser

160 GSa/s All-Optical Pulsed Sampling with a Single Semiconductor Optical Amplifier

Low timing jitter 40 Gb/s all-optical clock recovery based on an amplified feedback laser diode

Real-time Fourier-domain optical vector oscilloscope

100 Gb/s All-Optical Clock Recovery Based on a Monolithic Dual-Mode DBR Laser

On-field measurement trial of 4×128 Gbps PDM-QPSK signals by linear optical sampling

Detection And A/D Conversion For 10ghz Periodic Signals With Optical Sampling

850Nm Gain-Switched Pulse Laser and Its Application in Photon Counting OTDR

40Gbits/s All-Optical Clock Recovery for Degraded Signals Using an Amplified Feedback Laser

Fast Linear Optical Sampling with High Repetition-Frequency Using Fiber Delay Lines

783-MHz fundamental repetition rate all-fiber ring laser mode-locked by carbon nanotubes