Abstract:The high-precision machine tool's dynamic, static, and rigid nature directly affects the machining efficiency and surface quality. Static and dynamic analyses are essential for the design and improvement of precision machine to ensure good tool performance under difficult and demanding machining conditions. In this study, the performance of a high-precision machine tool was analyzed using its virtual model created using CAD. Static and model analysis using ANSYS Workbench software was conducted to establish the tool's static deformation and static stiffness. Furthermore, the static and dynamic characteristics of the tool were explored using a finite element modeling approach to study their performance. In particular, the structure, static force, modal, frequency spectrum, and topology optimization of machine tools were primarily analyzed. Using model analysis, we found the first four different frequencies (22.5, 28.9, 40.6, and 47.4 Hz) and vibration type, which suggested of a weak link. Further static structural analysis revealed that the deformation of the spindle was 67.26 μm. An experimental static rigidity analysis was performed, and the experimental deformation values of the tool and spindle were obtained. The static and dynamic characteristics, as well as the accuracy and efficiency of the finite element model, were verified by comparing the data with the finite element analysis (FEA) results. Subsequently, we modified the settings and analysis model to ensure that the analysis results were consistent with the experimental findings. The error between the two results was within 1.56%. For an applied load of 5000 N on the spindle nose, the tool nose transient response was 0.5 s based on transient analysis. Under the condition that the structural deformation is as constant as possible, the lightweight structure may achieve the minimum weight and enhance the natural frequency; thus, the ideal structure will be obtained, and finite element analysis will then be performed. The optimal conditions for topology optimization include a lightweight structure, reduced structural deformation, and increased natural frequency of the structure. The developed method improves structural optimization, increases the ability of the product to be manufactured, and offers designers a variety of price-effective options.

Analysis and Optimization of the Tensioning Effect on a Wood-Cutting Circular Saw Blade Tensioned by Multispot Pressure

Investigation on bolt initial tensioning of inner-diameter saw blade

An ANSYS/LS-DYNA simulation and experimental study of circular saw blade cutting system of mulberry cutting machine

The Mechanical Analysis of the Composite Reinforced Circular Saw Blade

Dynamics study and damping optimization of circular saw based on numerical simulation and experimental analysis

Structure Design Improvement and Stiffness Reinforcement of a Machine Tool through Topology Optimization Based on Machining Characteristics

A new in-processes active control method for reducing the residual stresses induced deformation of thin-walled parts

Aero-Engine Blade Cryogenic Cooling Milling Deformation Simulation and Process Parameter Optimization

The Analysis of Dynamic Characteristics in Reduction of the Circular Saw Idling Noise

Finite element analysis of residual stresses and thin plate distortion after face milling

Three-dimensional modeling and reconstructive change of residual stress during machining process of milling, polishing, heat treatment, vibratory finishing, and shot peening of fan blade

Research on the effect of fretting wear on the vibration characteristics of the tenon joint bladed disk

Numerical Modeling of the Effect of Cutting-Edge Radius on Cutting Force and Stress Concentration during Machining

Slicing process dynamic modelling of inner-diameter saw blade

Modeling and Performance Analysis of Machining Fixture for Near-Net-shaped Jet Engine Blade

Study on Residual Stress of Big Tilling Depth Rotary Blade for Laser Shock Peening

Stepwise varying of laser parameters to enhance the residual stress field in multiple laser shock processing: numerical verification of single-point region

Nonlinear dynamics analysis of pre-twisted blade with dovetail joint based on a two-dimensional micro-slip friction model

Theoretical investigation of machining-induced residual stresses in longitudinal torsional ultrasonic–assisted milling

Experimental Investigation of Effects of Polishing Process on Surface Residual Stress of TC4 Blade Based on Sensitivity Analysis

Finite element analysis and structure optimization of a gantry-type high-precision machine tool