Tuning the surface structure and phase structure of PtCu 3 nanoparticle for highly efficient electrocatalysts
Feng Liu,Yong Gao,Xuan Ouyang,Xinzhong Wang,Xuejiao Li,Fuxie Han,Wei Li,Feng Tan,Liexing Zhou,Xikun Yang
DOI: https://doi.org/10.1016/j.ijhydene.2022.04.206
IF: 7.2
2022-05-22
International Journal of Hydrogen Energy
Abstract:Significantly improving the catalytic activity and durability of platinum (Pt) based electrocatalysts is crucial for commercial application of fuel cells by tuning structure of Pt alloy nanoparticles. Here, we report a method of tuning structure of PtCu 3 alloy nanoparticle by annealing in different atmospheres. The detailed analyses showed that evolution of surface structure and phase structure of PtCu 3 alloy nanoparticles heat-treated in N 2 atmosphere and N 2 /H 2 mixed atmosphere are mainly as follows: (1) when heat-treated in N 2 , the crystal phase of PtCu 3 has undergone a transformation from disordered PtCu 3 alloy to ordered PtCu 3 alloy and then to disordered PtCu 3 alloy with the increase of holding time from 30 min to 90 min; (2) when heat-treated in H 2 /N 2 , a Pt-rich surface is formed on the Pt–Cu nanoparticles due to Pt segregation induced by H 2 adsorption. Electrochemical measurements demonstrated that both PtCu 3 /C -N2 electrocatalysts prepared in N 2 and PtCu 3 /C -N2/H2 electrocatalysts prepared in H 2 /N 2 exhibit enhanced mass activities toward the oxygen reduction reaction (ORR) relative to Pt/C electrocatalyst in acidic media. In particular, when the holding time is 90 min, the obtained PtCu 3 /C -N2/H2 electrocatalysts with Pt-rich surface showed highest mass activity of 435 mA/mg Pt (at 0.9 V vs. RHE), which is four times greater than that of Pt/C catalyst (20 wt.% Pt, 115 mA/mg Pt ). This study provides a promising method for the reasonable design and preparation of low cost and high performance Pt-based electrocatalysts.
energy & fuels,electrochemistry,chemistry, physical