Abstract:Special nuclear material, like enriched uranium and plutonium, can contaminate environmental soils and water because of weapons development and testing or improper waste storage. To remediate affected lands and design long-term waste storage solutions, it is crucial to understand uranium speciation in the environment which depends on its complexation, oxidation state, and associated adsorption mechanisms. These phenomena are complex and poorly understood because they depend on many variables including the environmental pH, water or soil composition, uranium concentration, and surface chemistry of the minerals or soils. In previous studies, the proposed mechanism for adsorption of the hexavalent uranyl species, U VI O 2 2+ , on metal-oxide surfaces follows these general steps: 1) adsorption of U VI O 2 2+ on the mineral, followed by 2) reduction to U VI O 2 2+ due to the coupled reaction of a redox active species within the mineral. To gain better mechanistic insight into coupled electron transfer and adsorption phenomena associated with uranyl species, we demonstrate here a novel technique to probe an electrochemical interface to detect adsorbed uranium species under reducing conditions. In this technique, we monitor the transient response of the electrode potential immediately after electrochemical reduction of U VI O 2 2+ on a rotating disc electrode is halted. This potential relaxation rate, when analyzed, contains information on presence and coverage of surface adsorbed species. In combination with electrochemical quartz crystal microgravimetry (e-QCM), these experiments confirm the presence of an adsorbed layer of uranium ions during the reduction of U VI O 2 2+ . To simulate uranyl adsorption on minerals under environmental conditions, future work will aim to probe adsorption onto a metal-oxide film prepared on an e-QCM electrode under varying redox and pH conditions.

Electrochemical Electron Transfer and Crystallization Process of Uranium (vi) in Sodium Salt Solution

Electrochemical Behavior and Reduction of UO22+ in LiCl-KCl Molten Salt

An Efficient System for Uranyl Electrodeposition and Investigation of the Uranyl Electrochemical Behavior

Electrochemical and spectrochemical analysis of U(VI) reduction in nitric acid solutions

Secondary metal ion-induced electrochemical reduction of U(VI) to U(IV) solids

The Electrode Kinetics of UCl3 in LiCl-KCl Molten Salt

The biomineralization process of uranium(VI) by Saccharomyces cerevisiae — transformation from amorphous U(VI) to crystalline chernikovite

Probing Adsorption of Uranium Species at Electrochemical Interfaces in Support of Environmental Radiochemistry

Electrochemical Behavior of the System of Uranium(Vi) Extraction with Cmpo-Ionic Liquid

Selective Electrochemical Separation and Recovery of Uranium from Mixture of Uranium(VI) and Lanthanide(III) Ions in Aqueous Medium

Isolation and Identification of a High-Efficiency Hexavalent Uranium Adsorption Strain and Preliminary Study of the Influencing Factors and Adsorption Mechanism

Influence of EDTA on the Interaction Between U(VI) and Calcite

Capturing aqueous uranyl ions into catalytic nanometric shells of liquid metal droplets for electrochemical reduction

Confirmation and elimination of cyclic electrolysis of uranium ions in molten salts

Synthesis of crystalline carbon nitride with molten salt thermal treatment for efficient photocatalytic reduction and removal of U(VI)

Electrochemistry of Uranium on Liquid Cadmium Electrode in LiCl-KCl Eutectic

Insight into the influence mechanism of chloride ions towards in-situ electric-induced uranium incorporation into magnetite

Stabilization of Uranium in Acid Ore Wastewater through Hydrothermal Mineralization-Induced Crystallization

Study on the electrodeposition of uranium in chloride molten salt

Electrochemical synthesis of EuVO4 for the adsorption of U(VI): Performance and mechanism

Uranium chemical species in LiCl-KCl eutectic under different conditions for the dissolution of U3O8