Application of the Steady-State Principle of Constant-Head Well Permeameter to Indirect Subsurface Drip Irrigation

Zhao Weixia,Zhang Zhenhua,Cai Huanjie,Shan Zhijie
DOI: https://doi.org/10.4141/cjss08083
2009-01-01
Canadian Journal of Soil Science
Abstract:Indirect subsurface drip irrigation (ISDI) is a method of increasing the irrigation water use efficiency of drip irrigation without the need to bury irrigation tubes and wet the soil surface. A major problem of ISDI is the mismatch between emitter discharge rate and water-conducting device dimension, which will result in over-filling of application water. In this paper, we propose to use the steady-state principle of constant-head well permeameter (CHWP) to quantify the relationship between emitter discharge rate and water-conducting device dimension for ISDI. CHWP tests and ISDI tests were carried out in a 300 m2 winter wheat fallow to verify its feasibility. The steady-state characteristic of these two methods was also studied using long-term infiltration. Results indicate that the equilibration time (110 min) in the ISDI tests was greater than that in the CHWP tests (30 min). The steady ponded depth in ISDI had a smaller variation than the steady water discharge rate in the CHWP. When using the steady-state principle of CHWP to design ISDI systems, there was significant linear correlation between predicted and measured ponded depth values (R2 = 0.8379). The soil field-saturated hydraulic conductivity calculated by these two tests was approximately equal. These results demonstrate that the steady-state principle of CHWP could be used to select appropriate irrigation systems for ISDI, and ISDI provides another technique to obtain the field-saturated hydraulic conductivity. Key words: Constant-head well permeameter, field-saturated hydraulic conductivity, indirect subsurface drip irrigation, steady-state
What problem does this paper attempt to address?