Abstract:Agricultural subsurface drainage is necessary for crop production in humid, poorly drained regions with frequent rainfall. Flooding and waterlogging have become more widespread and frequent in recent years, and effective measures should be adopted to increase the subsurface drainage capacity and alleviate flooding and waterlogging disasters after short-term heavy rainfall. However, subsurface drainage focused on the layout parameters (drain depth, drain spacing, etc.) in previous studies, and these measures were limited and cumbersome in the improvement of the flow rate of subsurface drainage. Thus, we aimed to alleviate the flooding and waterlogging threats to farmland and innovatively proposed a new method to increase the flow rate of subsurface drainage, namely siphon-type subsurface drainage. The paper evaluated the performance of the siphon-type subsurface drainage by the indoor sand tank test and the HYDRUS-2D model. Three factors were considered during the experiments: conventional and improved subsurface drainage; shallow, medium, and deep drain depth; and the outlet elevation, including the outlet elevation of the drain pipe under the non-siphon drainage and the outlet elevation of the siphon pipe under the siphon drainage. The results indicated that the siphon-type subsurface drainage performed better under the conditions of steady-state ponding and ponding subsided. The flow rate of the siphon-type subsurface drainage was 27.1-45.7%, 41.8-89.8%, and 39.3-50.5% higher than that of conventional, thin-improved, and thick-improved subsurface drainage with non-siphon drainage under steady-state ponding, respectively. It also had a significant advantage when the outlet elevation was the same. The siphontype subsurface drainage could increase the flow rate during ponding subsided and reduce the flow rate attenuation degree before the ponding disappears. The flooding removal effect of the siphon-type subsurface drainage was significantly better than that of non-siphon subsurface drainage. The water head and flow rate were used to calibrate and validate the HYDRUS-2D model. The results indicated that the simulated values of flow rate matched well with the measured ones and the relative errors were less than 10%. The influence range and absolute values of the negative water head increased with the decrease of outlet elevation, and the increase effect of flow rate increased with the decrease of the water head. The siphon-type subsurface drainage has more control distance than the non-siphon. The advantages of siphon-type subsurface drainage are not only prominent in quart sand but also applicable to field soil. The results of this study could provide technical support for the application of flooding and waterlogging removal in areas where waterlogging is prone to occur and could improve the ability of agricultural production to address waterlogging disasters.

Comparison of recharge from drywells and infiltration basins: A modeling study

Groundwater Recharge from Drywells Under Constant Head Conditions

Evaluating drywells for stormwater management and enhanced aquifer recharge

Estimating the impact of vadose zone heterogeneity on agricultural managed aquifer recharge: A combined experimental and modeling study

Modeling bioretention hydrology: Quantifying the performance of DRAINMOD-Urban and the SWMM LID module

Managed artificial recharge through drywells

Comparison of performance of WIOA, FR, SI, and MIF for groundwater recharge identification: an integrated framework

Methodology to simulate unsaturated zone hydrology in Storm Water Management Model (SWMM) for green infrastructure design and evaluation

Coupling SWAT Model and CMB Method for Modeling of High-Permeability Bedrock Basins Receiving Interbasin Groundwater Flow

The effect of typical geological heterogeneities on the performance of managed aquifer recharge: physical experiments and numerical simulations

Application of the Steady-State Principle of Constant-Head Well Permeameter to Indirect Subsurface Drip Irrigation

Infiltration Simulation and System Design of Biogas Slurry Drip Irrigation Using Hydrus Model

Modelling regional effects of artificial groundwater recharge in a multilayer aquifer characterized by perched water tables

Assessing SWAT+ Performance in Simulating Drainage Water Management and Parameter Transferability for Watershed-Scale Applications

Modeling the Effects of Artificial Drainage on Agriculture‐Dominated Watersheds Using a Fully Distributed Integrated Hydrology Model

Evaluating the contribution of subsurface drainage to watershed water yield using SWAT+ with groundwater modeling

Assessing the Hydrological Impact of Gravity‐Fed Irrigation on Groundwater Recharge Using Long‐Term Isotope Monitoring and Modelling

Effect of Surface Water Level Fluctuations on the Performance of Near-Bank Managed Aquifer Recharge from Injection Wells

Experimental and Modeling Evaluation of Siphon-Type Subsurface Drainage Performance in Flooding and Waterlogging Removal

Coupling a large-scale hydrological model (CWatM v1.1) with a high-resolution groundwater flow model (MODFLOW 6) to assess the impact of irrigation at regional scale

Comprehensive two-dimensional analytical modeling of groundwater levels in bi-directional sloping heterogeneous aquifers under variable recharge conditions