Abstract:Structural deformation and variation in internal force are important considerations with regard to bridge health monitoring. Field measurements demonstrate that thermal effects of cable-stayed bridges—which represent high-order statically indeterminate structures—are extremely complex and nearly impossible to explicate in terms of temperature-limit states assumed during the design stage. Based on monitoring data recorded for the Shanghai Yangtze River Bridge—a steel box girder, twin-tower cable-stayed bridge with a 730 m central span—simultaneous investigations were performed concerning effects of seasonal as well as diurnal temperature variations on thermally induced changes in the mid-span vertical displacement ( D T ) and horizontal projection length ( L T ) of the girder, distance between the two tower tops ( S T ), structural total or elastic strains ( ε M / ε E ) at the mid-span section and average cable tensions of the longest centre-span cables ( F T ). In terms of variation amplitudes, correlations between temperature and structural response of a cable-stayed bridge can be classified into two modes. In the first mode, annual variation amplitudes are observed to be significantly larger compared with diurnal amplitudes. This applies to parameters L T , S T and ε M . In the second mode, annual variation amplitudes approximately equal diurnal amplitudes. This is true for parameters D T , ε E and F T . Temperature variables upon which structural response of cable-stayed bridges primarily depends usually differ from one another in that L T , S T and ε M are governed exclusively by the average girder temperature while D T and F T are simultaneously determined by the cable and average girder temperatures; parameter ε E is dominated by the temperature difference between the top and bottom plates of the girder. This study establishes a sound understanding of behavioural patterns in cable-stayed bridges to facilitate the determination of feasible measurement-point locations, useful with regards to bridge-monitoring systems, as well as selection of appropriate temperature variables for thermal-response modelling.

Thermal behaviors of Tsing Ma Suspension Bridge

Evaluation of Thermal Effects on Cable Forces of a Long-Span Prestressed Concrete Cable–Stayed Bridge

Control Measures for Thermal Effects During Placement of Span-Scale Girder Segments on Continuous Steel Box Girder Bridges

Temperature Field and Stress Field of Prestressed Concrete Box-Girder Bridge

Global temperature behavior monitoring and analysis of a three-tower cable-stayed bridge

Temperature behaviors of an arch bridge through integration of field monitoring and unified numerical simulation

Strain-temperature Correlation Analysis of a Tied Arch Bridge Using Monitoring Data

Thermal boundary conditions for heat transfer analysis of bridges considering non-uniform distribution of internal air temperature by computational fluid dynamics

Heat and Moisture Transfer in Wall-to-floor Thermal Bridges and Its Influence on Thermal Performance

Finite Element Analysis of 3D Heat Transfer of Typical Thermal Bridge of Self-Thermal Insulation in Hot-Summer and Cold-Winter Zone

Investigation of temperature effects on wide steel box girder of suspension bridge based on long-term monitoring data

Investigation of temperature-induced effect on rail-road suspension bridges during operation

Thermal Simulation on the Flat Steel Box Girder of the Maputo Bridge under Solar Radiation

Analysis of Temperature Stress in Bridges Considering Vertical and Transverse Temperature Gradient

A comprehensive study of the thermal response of a long-span cable-stayed bridge: From monitoring phenomena to underlying mechanisms

Temperature effects on cable stayed bridge using health monitoring system: a case study

All-Weather Thermal Simulation Methods for Concrete Maglev Bridge Based on Structural and Meteorological Monitoring Data

Analysis of Vertical Temperature Gradients and Their Effects on Hybrid Girder Cable-Stayed Bridges

Thermal Effect on Dynamic Characteristics of Concrete Girder Bridges

Modeling of Temperature Distribution in a Reinforced Concrete Supertall Structure Based on Structural Health Monitoring Data

Temperature Field Boundary Conditions and Lateral Temperature Gradient Effect on a PC Box-Girder Bridge Based on Real-Time Solar Radiation and Spatial Temperature Monitoring