Abstract:The BeiDou Navigation Satellite System (BDS) has developed rapidly, and the combination of BDS Phase II (BDS-2) and BDS Phase III (BDS-3) has attracted wide attention. It is found that there are code ISBs between BDS-2 and BDS-3, which may have a certain impact on the BDS-2 and BDS-3 combined positioning. This paper focuses on the performance of BDS-2/BDS-3 combined B1I single-frequency pseudorange positioning and investigates the positioning performance with and without code ISBs correction for different types of receivers, include geodetic GNSS receivers and low-cost receivers. The results show the following: (1) For geodetic GNSS receivers, the code ISBs of each receiver is about −0.3 m to −0.8 m, and the position deviation is reduced by 7% after correcting code ISBs. The code ISBs in the baseline with homogeneous receivers has a little influence on the positioning result, which can be ignored. The code ISBs in the baseline with heterogeneous receivers is about −0.5 m, and the position deviation is reduced by 4% after correcting code ISBs. (2) The code ISBs in the low-cost receivers are significantly larger than those in the geodetic GNSS receivers, and the impact on the positioning performance of the low-cost receivers is significantly greater than that on the geodetic GNSS receivers. After correcting the code ISBs, the position deviation of low-cost receivers can be reduced by around 12% for both undifferenced and differenced modes. (3) For low-cost receivers, correcting the code ISBs can increase the number of epochs successfully solved, which effectively improves the low-cost navigation and positioning performance. (4) The carrier-phase-smoothing method can effectively reduce the distribution dispersion of code ISBs and make the estimation of ISBs more accurate. The STD values of estimated code ISBs in geodetic GNSS receivers are reduced by about 40% after carrier-phase smoothing, while the corresponding values are reduced by about 7% in low-cost receivers due to their poor carrier-phase observation quality.

Quantization Effect on BeiDou Signal in Jamming Environment

The upper bound of anti-jamming capability for GNSS receivers with finite quantization bits

ADC design in anti-jamming spread spectrum receivers

Precise BER analysis of dual-channel reception of QPSK in Nakagami fading and cochannel interference

Research on Space-Time Anti-jamming Algorithm of Beidou Navigation Receiver

A Real Data Based Carrier-to-Noise Density Ratio Evaluation of GNSS Signal in Interference Environment

Exploiting Jamming-Caused Neighbor Changes for Jammer Localization

Analysis of Electromagnetic Interference Effect of the Pulse Interference on the Navigation Receiver

An Analytical Model for BDS B1 Spreading Code Self-Interference Evaluation Considering NH Code Effects

Jam resistance performance of UWB BPM impulse radio with time hopping vs. direct sequence

Miniaturized BDS Anti-jamming Antenna Research

Experimental Evaluation of the Impact of Different Types of Jamming Signals on Commercial GNSS Receivers

Research on the space-time anti-jamming algorithm for satellite navigation receiver

A Comprehensive Signal Quality Assessment for BDS/Galileo/GPS Satellites and Signals

Analysis of Multi-Antenna GNSS Receiver Performance under Jamming Attacks

Performance Analysis of Directional Modulation with Finite-Quantized RF Phase Shifters in Analog Beamforming Structure.

A Satellite Navigation Signal Acquisition and Interference Suppression Method in a Complex Electromagnetic Environment

An adaptive hybrid blanking algorithm to mitigate the DME pulse interference on BDS B2a receivers

Analysis of Multipath Error Characteristics of BeiDou Navigation Signal

Optimum Quantization Scaling for Noisy Signals in UWB Scenarios.

Influence of Inter-System Biases on Combined Single-Frequency BDS-2 and BDS-3 Pseudorange Positioning of Different Types of Receivers