Abstract:With the increasing penetration level of renewable energy resources with less system inertia, accurate estimation of the power system inertia has become a critical issue for maintaining the frequency stability of the entire power system. To tackle out this challenging task, a two-stage data-driven method is proposed in this paper for estimating the system inertia from disturbed PMU measurements. First, by integrating its low-order system frequency response model with the first-order turbine model, analytical expressions of the frequency response under the steady-state and these transient oscillatory components are derived. Then, based on this parametric model, a two-stage estimation algorithm will be developed. At the first stage, system parameters of oscillatory components can be extracted from PMU measurements by Estimation of Signal Parameters via Rotational Invariance Techniques (ESPRIT). By utilizing frequency measurement data from PMUs and those estimated parameters from the ESPRIT algorithm, a weighted nonlinear least square approach is applied at the second stage to estimate physical parameters such as system inertia, damping coefficient, turbine time constant, and regulation coefficient. To validate the effectiveness of the proposed method, simulation studies of IEEE 39- bus system is investigated. Historical PMU measurements from various contingencies of Taiwan Power System will also be explored. All of these results demonstrated that the proposed method provides satisfactory performances with the mean relative error less than 10%. Comparisons with other existing methods are performed to demonstrate the advantage of the proposed method.

Ambient-Data-Driven Modal-Identification-Based Approach to Estimate the Inertia of an Interconnected Power System

Wavelet-based Electromechanical Mode Shape Online Identification from Ambient Data

Identification Approach to Dynamic Equivalents of the Power System Interconnected with Three Areas

Comparative Study of Data-driven Area Inertia Estimation Approaches on WECC Power Systems

Estimating The Electromechanical Oscillation Characteristics Of Power System Based On Measured Ambient Data Utilizing Stochastic Subspace Method

An Improved Inertia Measurement Method Based on EMD Decomposition

Ambient PMU Measurements Based Online Regional Inertia Estimation and Monitoring

A Two-Stage Data-Driven Method for Estimating the System Inertia Utilizing Event-Driven PMU Measurements

Improvement of Electromechanical Mode Identification from Ambient Data with Stochastic Subspace Method

Dynamic Estimation of Power System Inertia Distribution Using Synchrophasor Measurements

Ambient-Frequency-Data Based System-Level Inertia Estimation Using Physical Equation and its Practice on Hawaii Islands

Estimation of Power System Inertia Using Discrete Dynamic Regressor Extension and Mixing

Inertia estimation of multi-area power systems using tie-line measurements and modal sensitivity analysis

Identification of Low-Frequency Oscillation Modes Based on Frequency Domain Decomposition Method and Wide Area Ambient Measurements

Online Evaluation for the POI-Level Inertial Support to the Grid via Ambient Measurements

Data-Driven Mode Identification Method for Broad-Band Oscillation of Interconnected Power System

Oscillation Mode Identification Method of Renewable Energy Stations Based on Dynamic Mode Decomposition with Control

Real-Time Damping Estimation on Nonlinear Electromechanical Oscillation

Inertia Evaluation for Power System Based on Quasi-Steady-State Data

Real-time estimation of time-varying inertia for non-synchronous devices using streaming dynamic mode decomposition

Identification of Mode Shapes Based on Ambient Signals and the IA-VMD Method