Abstract:Abstract The construction of tunnel portal not only has to face the challenges of complex geological conditions such as shallow buried and asymmetrically loaded, but also needs to consider the adverse effects of factors such as the layout form of the tunnel. Thus, the construction of portal has always been the difficulty and focus of tunnel engineering construction. Under the coupling of multiple adverse factors such as complex geological conditions and special layout form, the tunnel portal is prone to excessive deformation, supporting structures cracking and even collapse during the excavation. In this study, a shallow buried and asymmetrically loaded tunnel with small clear-distance in northwest China was taken as an engineering case. Aiming at the distresses of slope instability, peeling off and block falling of primary support concrete and cracking of secondary lining concrete in the tunnel portal construction, combined with field investigation, statistical analysis, numerical simulation and deformation monitoring, the failure mechanism of supporting structures was deeply studied, and the corresponding treatment measures were proposed. The research results indicated that the loose and broken gravel soil in the shallow buried section, asymmetrical loading, surface water infiltration, and short construction spacing between two tunnels were the main triggers of supporting structures failure. Affected by the topographic bias, the loose load generated by the surrounding rock on the deep buried side squeezed the entire tunnel to the shallow buried side after the portal excavation. And this deformation trend became more significant after the gravel soil was deteriorated by water immersion. The retaining wall produced a clockwise rotation deformation around the wall corner in the process of limiting the tunnel deviation, and the local wall body cracked due to the excessive tensile stress. The primary support concrete and secondary lining concrete produced excessive asymmetrical deformation because of the significant asymmetrical loading. The concrete with excessive deformation was cracked by obvious tensile or shear stress. The following tunnel excavation had a significant negative impact on the stability of the prior tunnel. Combining the failure mechanism of the supporting structures and the characteristics of the continuous development of cracks, the treatment measures of ‘stabilize the stratum first and then treat the cracks’ were proposed, including the backfilling and tamping the shallow buried side at tunnel portal, reinforcing the interlaid rock by ground surface grouting, setting intercepting ditch at the slope top, staggering a certain safe excavation distance between the following tunnel and the prior tunnel. The field monitoring and patrol inspection results indicated that the proposed treatment measures had achieved the expected results. The research results can provide corresponding construction experience and suggestions for similar projects in the future.

Analysis of Collapse Mechanism and Treatment Evaluation of a Deeply Buried Hard Rock Tunnel

Instability Mechanism of Shallow Tunnel in Soft Rock Subjected to Surcharge Loads

Failure mechanism and treatment measures of supporting structures at the portal for a shallow buried and asymmetrically loaded tunnel with small clear-distance

Failure mechanism and treatment measures of supporting structures at portal for a shallow buried and asymmetrically loaded tunnel with small clear-distance

Deformation mechanism and collapse treatment of the rock surrounding a shallow tunnel based on on-site monitoring

Comprehensive Collapse Investigation and Treatment: an Engineering Case from Qingdao Expressway Tunnel

Collapse mechanism and treatments of a deep tunnel in the weathered granite fault zone

Research on collapse mechanism of Mayakou tunnel under flow-stress coupling and its treatment

MECHANICAL CHARACTERISTICS AND TREATMENT METHOD OF COLLAPSE OF TUNNEL WITH HALF-HARD AND HALF-SOFT ROCKS ALONG ITS TRANSVERSE SECTION

Failure analysis and countermeasures of highway tunnel crossing fault fracture zone in coal-bearing strata: A case study

Roof Collapse Mechanism of Weak Surrounding Rock for Deep-Buried Tunnels under High Geostress Conditions

Dynamic risk evaluation method of collapse in the whole construction of shallow buried tunnels and engineering application.

Treatment Technique of Collapse in Tiefeng Mountain Tunnel

Failure mechanism and countermeasures of limestone tunnel collapse due to rainfall under complex terrain: A case study

Research on Large Deformation Mechanism and Countermeasures of Shallow Buried Soft Rock Tunnel with Abundant Water

Study of the disaster-causing mechanism and reinforcement measures for soft rock deformation and lining cracking

Analysis of Tunnel Collapse Mechanism Due to Dislocation and Fracture of the Surrounding Rock Block, and a Method to Predict the Collapse Height

Mechanism and prevention of “Closed Door” collapse in tunnel construction: A case study

Analysis and countermeasures of large deformation of deep-buried tunnel excavated in layered rock strata:A case study

Numerical simulation and treatment methods for a collapsed highway tunnel

Analysis of Factors Influencing Tunnel Block Collapse in Blocky Rock Masses: Insights from Large-Scale Model Experiments and DDA Simulations