Abstract:The levels of nitric oxide (NO) and nitrogen oxide (NO 2 ) are trace gases in the order of ppb, which are the main products of fossil fuel, anthropogenic combustion, natural lightning and microbial emissions, and are important for further analysis of air quality. Photoacoustic spectroscopy (PAS) technique, which is based on absorption at the wavelength of 403.65 nm, has been used for NO 2 measurements. In this study, a dual-channel PAS system for NO 2 and NO x detection is reported. The PAS method is capable of measuring species with good sensitivity and accuracy. The calibrated slopes of photoacoustic cavity A and B are 0.040 μv/ppb and 0.039 μv/ppb, respectively. And the detection limits of the developed PAS system for NO 2 and NO x measurements are estimated to be about 1.47 ppb (3σ, 60 s) and 1.50 ppb (3σ, 60 s), respectively. In order to reduce the influence of local noise, the photoacoustic cavity with multiple buffer partitions is designed and the corresponding photoacoustic frequency of the photoacoustic pool is analyzed. The sound pressure value and resonance frequency of the photoacoustic pool gradually decrease with the increase of the number of buffer partitions, but the amplitude is small. The relationship between the gas absorption cross section, volume fraction, laser power and photoacoustic excitation signal is derived. After deducting the influence of local noise, the photoacoustic response gradients of dual-channel cavities are obtained, the linear fitting of the response gradient of both cavities is good, the correlation R 2 is greater than 0.99, and the fitting slope is 0.040 and 0.039 respectively. The influence of O 3 generated by photolysis of the mercury lamp is considered under different NO level conditions. An intercomparison between the system and a cavity ring-down system (CRDS) independently developed by our research group showed a good agreement for measuring the ambient atmosphere NO 2 gas. The results of NO 2 showed a linear correction factor (R 2 ) of 0.943 in a slope of 0.944 ± 0.002, with an offset of (0.636 ± 0.021) ppb. The accuracy of NO 2 measurement by the photoacoustic spectroscopy system was verified. In addition, the simultaneous measurement of NO and NO 2 by dual-channel cavity photoacoustic spectroscopy technique was deployed. These observations indicate that NO 2 and NO concentrations can be effectively observed with the dual-channel PAS instrument.

Sub-ppb Level Detection of Nitrogen Dioxide Based on an Optimized H-type Longitudinal Acoustic Resonator and a Lock-in White-Light Interferometry Demodulation Algorithm

Fully Integrated Photoacoustic NO 2 Sensor for Sub-ppb Level Measurement.

A Compact NO2 Gas Sensor with an Optimized Photoacoustic Cell and 450 nm-LD

Sub‐ppb nitrogen dioxide detection based on resonant photoacoustic spectroscopy

Fully Integrated Photoacoustic NO2 Sensor for Sub-ppb Level Measurement

Optimization Design of H-Type Differential Photoacoustic Cell and NO<sub>2</sub> Detection

Highly Sensitive Sphere-Tube Coupled Photoacoustic Cell Suitable for Detection of a Variety of Trace Gases: NO2 as an Example

Ppb-level Nitric Oxide Photoacoustic Sensor Based on a Mid-Ir Quantum Cascade Laser Operating at 52 °C

Design of Long Optical Path and Resonant Sphere-Tube Coupled Photoacoustic Cell

Optimization design of sphere‐tube‐coupled photoacoustic cell and application of nitrogen dioxide detection

Simultaneous measurement of NO and NO 2 by dual-channel cavity photoacoustic spectroscopy technique

Detection of Nitrous Oxide by Resonant Photoacoustic Spectroscopy Based on Mid Infrared Quantum Cascade Laser

Highly Sensitive Near-Infrared Gas Sensor System Using a Novel H-type Resonance-Enhanced Multi-Pass Photoacoustic Cell

Gas Measurement System of No and No2 Based on Photoacoustic Spectroscopy

Ppb-level detection of methane based on an optimized T-type photoacoustic cell and a NIR diode laser

Photoacoustic spectroscopy of NO$_2$ using a mid-infrared pulsed optical parametric oscillator as light source

Design and Optimization of Off-Beam No2 Qepas Sensor by Use of E-Mocam with A High Power Blue Laser Diode

Development of High-Precision NO2 Gas Sensor Based on Non-Dispersive Infrared Technology

QEPAS Based Ppb-Level Detection of CO and N_2O Using a High Power CW DFB-QCL

Integration of T-type Half-Open Photoacoustic Cell and Fiber-Optic Acoustic Sensor for Trace Gas Detection.

NO<sub>2</sub> Measurement Using Fiber Coupled Broadband LED Source Combining a Herriott Multi-Pass Cell