Abstract:Small animal PET scanners need to have a high spatial resolution since the size of the organs of small animals is much smaller than that of humans, and also need to have a high sensitivity since the allowed injection dose is limited by the radiation dosimetry of the small organs. To simultaneously achieve high spatial resolution and high sensitivity for a small animal PET scanner, detectors with high position resolution, high efficiency and high depth of interaction (DOI) resolution are required. In this work, three 17 x 17 pixelated LYSO arrays with crystal size of similar to 0.5 mm and an outer dimension of 10 x 10 x 20 mm(3) are fabricated. The first LYSO array uses 80 mu m thick BaSO4 reflector. The second and the third LYSO arrays use 65 mu m thick Toray reflectors. The outermost side of the third LYSO array is also wrapped with k9 glass of the same size as the crystals in the array in order to improve the light collection and flood histogram quality for the edge crystals. The LYSO arrays are read out with two Hamamatsu SiPM arrays from both ends. The SiPM array is 4 x 4, with 3 x 3 mm(2) pixel size and 0.2 mm gap in between the SiPM pixels. The SiPM array is read out with a resistor network circuit to reduce the number of signals from 16 to 4. The performance of the detector in terms of flood histograms, energy resolution, DOI resolution and timing resolution was measured. All three detectors provide good flood histograms and all crystals in an array can be clearly resolved. The average DOI resolutions of individual crystals are 1.84, 1.98 and 1.93 mm for the three detectors for events with energy E > 350 keV. The BaSO4 array has higher light output and provides a better average crystal energy resolution of 21.0 %. The photopeak amplitude of the Toray arrays changes with depth, which results in worse energy resolutions of 24.4 % and 23.8 % for the two detectors respectively. The average timing resolutions of individual crystals are 1.23, 1.27 and 1.24 ns for the three detectors for events with E > 350 keV. All three detector modules achieved high position resolution (0.5 mm crystal size), high efficiency (20 mm crystal length) and high DOI resolution (<2.0 mm) and can be used to build a high sensitivity small animal PET scanner with spatial resolution approaching the physical limit.

An Investigation of a Coincidence Detection System for an All-Digital Small Animal PET Scanner

An investigation of coincidence detection methods for Trans-PET

Evaluation of a Prototype of New Position-Sensitive Detector for a Small Animal PET System

Crystal Identification for a Dual-Layer-offset LYSO Based PET System Via Lu-176 Background Radiation and Mean Shift Algorithm

Analytic Modeling of Software Coincidence Detection in PET

A Modular Low Dead-Time Coincidence System for High Resolution Pet Cameras

A compact PET detector module using SiPMs and MVT digitizers

Sub-Detector Unit Timing Calibration for Brain Pet Based on L1-Norm Constraint

Trans-Pet: Towards Plug and Imaging Coincidence Measurement

Effect of Crystal surface treatment on the timing response of a DOI detector for PET

INVESTIGATION OF LSO SCINTILLATORS FOR HIGH-RESOLUTION PET DETECTORS

Development of a MR-compatible DOI-TOF detector module for PET imaging systems

An Investigation of Digital Signal Processing for Shaped Pulses for All-Digital Pet

Initial Implementation of LYSO-PSPMT Block Detector with an All Digital DAQ System

Development of a Compact DOI–TOF Detector Module for High-Performance PET Systems

Development of a Prototype PET Scanner with Depth-of-interaction Measurement Using Solid-State Photomultiplier Arrays and Parallel Readout Electronics.

Development of a small animal SPECT imager with LYSO scintillator arrays and PSPMTs

Dual-ended Readout Small Animal PET Detector by Using 0.5 Mm Pixelated LYSO Crystal Arrays and SiPMs

Initial Implementation of All-Digital PET DAQ System

Comparing Crystal Identification Algorithms for Pet Block Detectors

A Novel Sub-Millimeter Resolution Pet Detector with Tof Capability