Flow Separation Around a Square Cylinder at Low to Moderate Reynolds Numbers

Hongyi Jiang,Liang Cheng
DOI: https://doi.org/10.1063/5.0005757
IF: 4.6
2020-01-01
Physics of Fluids
Abstract:Flow (of a Newtonian and incompressible fluid) separation around a square cylinder for Reynolds numbers (Re) in the range of 10–400 is investigated through direct numerical simulations. In contrast to the general belief that for a square cylinder, the flow would always separate at the leading and/or trailing edges of the cylinder, this study shows that the flow (both time-averaged and instantaneous) may not separate at the sharp corners for a certain range of moderate Re values. Instead, separation emerges at approximately a quarter of the cylinder length downstream of the leading edge at critical Re values of 100.36 and 96 for the time-averaged and instantaneous flows, respectively. With the increase in Re, the time-averaged separation location gradually moves toward the leading edge, while its instantaneous variation range reduces. The evolution of the separation pattern with Re is categorized with a fine Re resolution of 1. A critical point is identified at Re = 156 (for the time-averaged flow), where a saddle point emerges away from the upper/lower surface of the cylinder to give rise to wake flow entrainment to the upper/lower side of the cylinder. The rate of the entrained flow is governed by the location of the saddle point. The flow three-dimensionality occurring at Re > 165.7 affects the location of the saddle point but has almost no influence on the location of the separation point. The corresponding physical mechanism is explained.
What problem does this paper attempt to address?