Abstract:For the successful application of boundary lubrication, detailed investigations about the influence of preparation process on molecular films are needed. In this paper, a specially designed device was used for the film preparation. The scanning electron microscope (SEM) combined with atomic force microscope (AFM) was employed to characterize the surface morphology and nanotribological behavior of molecular films. After the liquid phase deposition, molecular films are randomly and densely distributed over Ti-doped diamond-like carbon (Ti-DLC) substrates. Through rigorous surface treatments, island-like molecular films were finally achieved on substrate surfaces. The surface friction of molecular films is obviously lower than that of Ti-DLC surfaces. Then, pin-on-disk tribotests were performed to study the macrofriction behavior of molecular films under different preparation parameters. Based on the orthogonal experiment, the effect of five preparation parameters (solution weight percent, smearing force and processing time of three smearing steps) on initial friction coefficient of molecular films was investigated. The results indicated that the order of significance levels is as follows: processing time of the second smearing step > solution weight percent > processing time of step 1 > processing time of step 3 > smearing force. For the purpose of friction reduction, the appropriate level ranges are 0.75% (Solution), 2.5 N-15 N (Force), 1 min-10 min (Step 1), 1 min-2 min (Step 2) and 1 min, 2 min, 5 min and 15 min (Step 3). The initial friction coefficient under the optimized conditions is around 0.112, and the equilibrium friction coefficient is around 0.162, which is lower than that of unlubricated Ti-DLC substrates.

Preparation, Characterization and Investigation of Molecular Films Coated on Diamond-Like Carbon Substrate

Tribological Behavior of Diamond-Like Carbon Film with Different Tribo-Pairs: A Size Effect Study

Effect of Surface Morphology on the Frictional Behaviour of Hot Filament Chemical Vapour Deposition Diamond Films

Afm/Ffm Study Of Micro/Nano-Tribological Properties Of Diamond-Like Carbon Film

Tribological Behaviors of DLC Films with Hierarchical Surface Textures under Water Lubrication: A Molecular Dynamic Simulation

Uncovering Diamond-like Carbon Films Super Lubricity: from Microscopic to Macroscopic

Experimental investigation on lubrication behavior of Ti/TiN/TiC/DLC solid film

Probing the friction mechanism of diamond-like carbon films in aqueous environments based on molecular dynamics simulations

A study of the wear mechanism of diamond-like carbon films

Molecular simulations of sliding process between Fe and DLC films on various boundary conditions

Molecular Dynamics Simulations on the Frictional Behavior of a Perfluoropolyether Film Sandwiched Between Diamond-Like-carbon Coatings.

Investigation on the Long-Duration Tribological Performance of Bilayered Diamond/Diamond-Like Carbon Films

Molecular Dynamics Simulation on Friction Process of Silicon-Doped Diamond-Like Carbon Films

Molecular Dynamics Simulations of Friction Process Between Diamond-Like Carbon and Si-DLC Films

Study on the Deposition and Tribological Properties of Diamond/dlc Composite Coating on WC-Co Substrate

Comparative Study on the Tribological Performance of HFCVD Diamond and DLC Films under Water Lubricating Condition

Molecular Dynamics Study of the Frictional Behaviors of Diamond-Like Carbon Films

Tribological Properties of Ti‐doped Diamond‐like Carbon Coatings under Dry Friction and PAO Oil Lubrication

Probing the Lubrication Mechanism of Rough Diamond-Like Carbon Films Against Silicon Nitride under Water

Tribological Behavior and Mechanism of Diamond-like Carbon Films

SPM investigation of diamond-like carbon and carbon nitride films