Effect of laser remelting processing on microstructure and mechanical properties of 17-4 PH stainless steel during laser direct metal deposition

Zhiyuan Yu,Yi Zheng,Junmei Chen,Chuanfeng Wu,Jijin Xu,Hao Lu,Chun Yu

DOI: https://doi.org/10.1016/j.jmatprotec.2020.116738

IF: 6.3

2020-01-01

Journal of Materials Processing Technology

Abstract:Laser direct metal deposition (DMD) is an efficient and flexible additive manufacturing technique which has broad application prospects, but it is also limited due to defects and mechanical anisotropy. Laser remelting (LR) is a process that after each layer is deposited, re-scan the deposition layer with the same slice data but without powder deliver, and it is often used during selective laser melting. Herein, LR process has been applied during the DMD process of a 17-4 PH steel to enhance the densification level and relieve the mechanical anisotropy. It is found that the thermal history, porosity and microstructural evolution are dependent on the LR energy density. Moreover, the roughness of top surface of the deposited layer and intralayer porosity decrease with increase of the laser remelting energy density. While for interlayer defects, there is an optimal LR energy density corresponding to the lowest interlayer porosity. Furthermore, LR process can enhance the holding time at high temperature, even sometimes heat the sample above Ac-1, resulting in change in contents of austenite and carbide. In addition, LR process greatly dilutes the pre-solidified texture. It was also proved that the flat defects inplane to the interlayer and the anisotropy of the crystallographic orientations are extremely harmful for the mechanical isotropy of the DMDed samples. Finally, sample manufactured with laser remelting at 15.0 J/mm(2) has the lowest porosity and most random crystallographic orientations resulting in near isotropous tensile strength, but the contribution of laser remelting to eliminate anisotropy in elongation is limited because of the interlayer defects.