Spreading and Bouncing of Liquid Alkane Droplets Upon Impacting on a Heated Surface

Mengxiao Qin,Yang Guo,Chenglong Tang,Peng Zhang,Zuohua Huang

DOI: https://doi.org/10.1016/j.ijheatmasstransfer.2020.120076

IF: 5.2

2020-01-01

International Journal of Heat and Mass Transfer

Abstract:This paper reports an experimental investigation on the impact dynamics of liquid normal alkane (nheptane, n-decane and n-tetradecane) droplets on a stainless steel surface using high speed photography and long distance microscopic techniques. Particular interest is paid to comprehensively explore the effects of liquid viscosity and surface roughness on droplet spreading and bouncing dynamics at different thermal hydrodynamic impact regions. Specifically, firstly, high speed images identified four regimes (evaporation, nucleate boiling, transition boiling and film boiling regime) of physical phenomena that couple the droplet spreading hydrodynamics, heat transfer and phase change. Bubbles generation due to the heating of the surface with compression of air disk under the droplet was observed and this phenomenon is firstly promoted and then inhibited with the increase of the wall temperature until finally no bubbles were observed when wall temperature is beyond the Leidenfrost point (T-L). Rim disturbances during spreading were observed at relatively high Weber number with wall temperature higher than T-L. Increasing wall temperature reduces the rim disturbance. Secondly, the measured non-dimensional maximum spreading diameter beta(max) decreases with the increase of surface temperature until it becomes a constant when temperature is beyond T-L. Rough surface was found to have a lower T-L because of larger vapor pressure provided by more nucleation sites. Finally, for wall temperature beyond T-L, droplet bounces up after a certain period of residence time (tau(r)). It takes more time for droplet to rebound at larger We because of larger beta(max) takes longer time to retract and rebound. Both surface roughness and liquid viscosity showed no influence on time to reach beta(max) (tau(max)), but significantly increases tau(r) by slowing the retracting process, which both should be considered in future model of tau(r). (C) 2020 Elsevier Ltd. All rights reserved.