Abstract:Unraveling the microstructural heterogeneity is an important issue to understand the physical and mechanical properties of metallic glasses. Structural relaxation below the glass transition temperature Tg and cold rolling at ambient temperature are effective ways to tune the state within the potential energy landscape of metallic glasses, modifying the microstructural heterogeneity. With the help of nanoindentation technique, by scrutinizing the local reduced modulus and hardness of a typical Zr50Cu40Al10 metallic glasses in different energy states (from structural relaxed state to rejuvenated state), we demonstrate that the enhancement of microstructural heterogeneity plays an important role in tailoring the mechanical behavior. The internal friction coefficient is obtained by fitting the experimental load-displacement curves with finite element simulation. It is found that internal friction coefficient decreases with the increase of concentration of flow defects. The stress exponent obtained from the creep stage shows a strong dependence on the structural state of metallic glasses. Effects of structural relaxation and rejuvenation on the structural state are rationalized in terms of the relative flow defects concentration. Finally, the statistics of discrete displacement bursts during the deformation process were probed. We find that the displacement bursts behavior is sensitive to the structural energy state (microstructural heterogeneity). The displacement bursts phenomenon changes from obvious (relaxed state) to unapparent behaviors (rejuvenated state). By given a physical schematic, the correlation between the displacement bursts size and the shear band size in the local plastic zones is well established, which will lead to a deeper understanding of the rejuvenation-induced plasticity of metallic glasses.

Analyses of Shear Band Emission in a Mg-based Bulk Metallic Glass Deformed at Different Nanoindentation Rates

Rate-dependent Plastic Deformation of TiZrHfCuNiBe High Entropy Bulk Metallic Glass

Unraveling the microstructural heterogeneity and plasticity of Zr<sub>50</sub>Cu<sub>40</sub>Al<sub>10</sub> bulk metallic glass by nanoindentation

Study of Serrated Flow and Plastic Deformation in Metallic Glasses Through Instrumented Indentation

Steady-State Serrated Deformation of Metallic Glass During Indentation

Effect of Pre-Existing Shear Bands on Mechanical Properties and Serration Behaviors in Bulk Metallic Glasses

Deformation Morphology Underneath the Vickers Indent in Bulk Metallic Glasses

Indentation Creep Dynamics in Metallic Glasses under Different Structural States

Characterization of Shear Banding in La-Based Bulk Metallic Glasses Through Indentation

Critical serrated flow features during nanoindentation in La-based bulk metallic glasses

The evolution of local mechanical properties of bulk metallic glasses caused by structural inhomogeneity

Strain Rate Dependence of Plastic Flow in Ce-based Bulk Metallic Glass During Nanoindentation

Localized Deformation Of A Cu46.25zr45.25al7.5er1 Bulk Metallic Glass

Deformation Behaviors of Cu29Zr32Ti15Al5Ni19 High Entropy Bulk Metallic Glass During Nanoindentation

Shear Bands in A Bulk Metallic Glass after Large Plastic Deformation

Room-temperature nanoindentation measurements of La-based bulk metallic glass

Flow serration and shear-band viscosity during inhomogeneous deformation of a Zr-based bulk metallic glass

Microstructural Evolution of Shear Bands Formation of Metallic Glasses under Different Loading Conditions and Strain Rates

Evaluation of Cu-Zr-Ti-In Bulk Metallic Glasses Via Nanoindentation

Rate-dependent Shear Banding and Fracture Behavior in a Ductile Bulk Metallic Glass

Localized deformation of a Cu<sub>46.25</sub>Zr<sub>45.25</sub>Al<sub>7.5</sub>Er<sub>1</sub>bulk metallic glass