Abstract:Highly ordered TiO2 nanotube array electrodes were successfully fabricated by a two-step anodization method on Ti sheet substrates in an electrolyte composed of ammonium fluoride, deionized water, and glycol. The tube wall was smooth, and the average internal and external diameters, wall thickness, and tube length achieved were 80 nm, 90 nm, 10 nm, and 9 μm, respectively. X-ray diffraction and field emission scanning electron microscopy results revealed that the TiO2 nanotube arrays presented an amorphous structure. When calcined at 300 °C, the arrays crystallized into the anatase phase, and the crystallization degree of the oxide layer increased as the temperature rose. Calcinating at 400 °C did not obviously disrupt the porous structure of the highly ordered arrays. However, higher temperature enlarged the diameter of the nanotube array and roughened the tube wall. When the temperature reached 600 °C, the nanotube mouth broke because of the excessive stress, causing the oxide layer’s thinness and nanotube mouth clogging. The photoelectric test showed that the electrode presented obvious photoresponse under 300–400 nm UV excitation (maximized at 360 nm). The degree of crystallization and the micro-structure of the oxide layer can significantly affect the photoelectric properties of the electrode. After calcination at 400 °C, the TiO2 nanotube arrays, with highly ordered tubular structure directly connected to the Ti substrate, can ensure the rapid transportation of photo-induced electrons to the Ti substrate, while the high crystallinity of the arrays can help reduce the defect density of the nanotube and extend the lifetime of the photo-induced carriers. The electrode showed the best photoelectric property, and the photocurrent intensity was maximized (29.6 μA). However, the calcination process with over-temperature resulted in substantial loss of the TiO2 oxide layer, mouth clogging, and a severe decline in the photoelectric properties.

Controllable Preparation of TiO 2 Nanorod Arrays for Enhanced Ultraviolet Photoresponse Performance of Au/TiO 2 Schottky Junction

High‐Performance Ultraviolet Photodetectors Enabled by van der Waals Schottky Junction Based on TiO2 Nanorod Arrays/Au‐Modulated Ti3C2Tx MXene

Fabrication of Well-Aligned Tio2 Nanotube Arrays with Outstanding Light-Induced Hydrophilicity Performance

Photo-assisted Deposition of Ag Nanoparticles on Branched TiO2 Nanorod Arrays for Dye-Sensitized Solar Cells with Enhanced Efficiency

Enhanced Photocatalytic and Photoelectrochemical Properties of Tio2 Nanorod Arrays Sensitized with Cds Nanoplates

Silver-Decorated TiO2Nanorod Array Films with Enhanced Photoelectrochemical and Photocatalytic Properties

Univariate Lattice Parameter Modulation of Single-Crystal-like Anatase TiO2 Hierarchical Nanowire Arrays to Improve Photoactivity

UV and Visible Light Photocatalytic Activity of Au/TiO2 Nanoforests with Anatase/Rutile Phase Junctions and Controlled Au Locations

An effective strategy for promoting charge separation by integrating heterojunctions and multiple homojunctions in TiO2 nanorods to enhance photoelectrochemical oxygen evolution

Balsam-Pear-Like Rutile/Anatase Core/Shell Titania Nanorod Arrays For Photoelectrochemical Water Splitting

Single-crystal TiO 2 /srtio 3 Core–shell Heterostructured Nanowire Arrays for Enhanced Photoelectrochemical Performance

Simultaneous Etching and Doping of TiO2 Nanowire Arrays for Enhanced Photoelectrochemical Performance

Regulating Phase Junction and Oxygen Vacancies of TiO2 Nanoarrays for Boosted Photoelectrochemical Water Oxidation

Study on Fabrication and UV Photoelectric Property of TiO2 Nanotube Array Electrodes.

Enhanced photoelectrochemical and photocatalytic performance of TiO 2 nanorod arrays/CdS quantum dots by coating TiO 2 through atomic layer deposition

The Effect Of Annealing Treatment And Atom Layer Deposition To Au/Pt Nanoparticles-Decorated Tio2 Nanorods As Photocatalysts

Visible Light Photoelectrochemical Properties of N-doped TiO2 nanorod arrays from TiN

Dendritic Au/TiO₂ nanorod arrays for visible-light driven photoelectrochemical water splitting

Photoelectrochemical Characteristics of TiO2 Nanorod Arrays Grown on Fluorine Doped Tin Oxide Substrates by the Facile Seeding Layer Assisted Hydrothermal Method

Photocatalytic synthesis and photovoltaic application of Ag-TiO2 nanorod composites.

Femtosecond laser mediated fabrication of micro/nanostructured TiO2- photoelectrodes: Hierarchical nanotubes array with oxygen vacancies and their photocatalysis properties