Abstract:The leaching behaviors of gold and silver from a complex sulfide concentrate in copper-tartrate-thiosulfate solutions were investigated in this paper. Experimental parameters, including temperature, initial pulp pH, and concentration of copper, tartrate, and thiosulfate, were systematically studied. The copper-tartrate-thiosulfate leaching system exhibits promising performance in dealing with the complex sulfide concentrate. Thiosulfate consumption could be greatly reduced due to the in-situ generation of thiosulfate derived from sulfur or disulfide ions. Increasing the temperature and concentrations of copper, tartrate, and thiosulfate can promote gold leaching. A low tartrate content and a moderate increase in temperature and copper and thiosulfate concentrations can accelerate silver leaching, but a higher temperature or copper content may depress silver extraction. A suitable pulp pH is critical for gold and silver leaching in copper-tartrate-thiosulfate solutions. An extraction of 74.50% Au and 36.33% Ag was obtained with the direct leaching of the concentrate, while the percentages can be significantly increased up to 82.60% and 70.38%, respectively, when leaching the calcine following the oxidative roasting pretreatment. The recycling of leaching solutions demonstrates that a suitable free tartrate content is of great significance in maintaining the stability of the novel system. As an alternative to the traditional cyanide or copper-ammonia-thiosulfate leaching processes, the copper-tartrate-thiosulfate leaching system provides an environmentally friendly, nontoxic, and relatively low-cost method for gold and silver leaching from ores or concentrates.

Extraction of Valuable Metals from Manganese–silver Ore

A Novel Process for the Separation and Recovery of Value-Added Metals from Manganese–silver Ores by EDTA/EDTA–2Na and Thiosulfate

Two-stage leaching of manganese and silver from manganese–silver ores by reduction with calcium sulfide and oxidation with copper(II)

Reducing Leaching of Manganese Mineral in Silver-manganese Ore with Scrap Iron As Reductant

Process for leaching of manganese and silver simultaneously from manganese-silver associated ore

Extraction of manganese and zinc from their compound ore by reductive acid leaching

Simultaneous Leaching of Manganese and Silver from Manganese–silver Ores at Room Temperature

A Comprehensive Utilization Process for Black Manganese-silver Ores by Pyrite Reducing Method

Manganese Extraction by Reduction–acid Leaching from Low-Grade Manganese Oxide Ores Using CaS As Reductant

A Novel Two-Stage Method of Co-Leaching of Manganese–Silver Ore and Silver-Bearing Pyrite Based on Successive Chemical and Bio Treatments: Optimization and Mechanism Study

Simultaneous Selective Chlorination and Carbothermic Reduction of High-Iron Manganese Ore for the Recovery of Manganese Chloride and Metallic Iron

Leaching conditions and characteristics of manganese from electrolytic manganese residue

Optimization of the Synergy Between Reduction Leaching of Manganese Anode Slime and Oxidation Pretreatment of Refractory Gold Ore by Response Surface Methodology

Simultaneous Leaching of Mn-containing Silver Ore andAs-containing Gold Ore

Extraction of Manganese from Iron Rich Mno2 Ores Via Selective Sulfation Roasting with So2 Followed by Water Leaching

Extraction and separation of strategic precious Ag from low-grade Mn - Ag ores in China: A short review of co-leaching and selective leaching processes

Selective extraction performance of Ni, Cu, Co, and Mn adopted by a coupled leaching of low-grade Ni-sulfide ore and polymetallic Mn-oxide ore in sulphuric acid solutions

Study on Leaching Silver from Refractory Silver Sulfide Materials

Selective Leaching of Silver-Rich Residue in NH4SCN Solution under Oxygen Pressure

Enhanced extraction of manganese from electrolytic manganese residue by electrochemical

Leaching of Gold and Silver from a Complex Sulfide Concentrate in Copper-Tartrate-Thiosulfate Solutions