Direct Measurement of Formaldehyde and Methanol Emissions from Gasohol Engine Via Pulsed Discharge Helium Ionization Detector

Yanju Wei,Shenghua Liu,Fangjie Liu,Jie Liu,Zan Zhu,Guangle Li
DOI: https://doi.org/10.1016/j.fuel.2010.04.015
IF: 7.4
2010-01-01
Fuel
Abstract:Unregulated formaldehyde (HCHO), acetaldehyde (CH3CHO) and methanol (CH3OH) emissions from M10 blend (methanol/gasoline=1/9 in volume) fuelled spark ignition (SI) engine were directly detected by a gas chromatography (GC) with a Gs-OxyPLOT capillary column and pulsed discharge helium ionization detector (PDHID). Chromatograms show that HCHO and CH3OH are well separated and linearly responded on PDHID within the range of 0.8–800μg/L. The method is proved suitable and reliable for measuring unregulated pollutants from the engine. Experimental results show that compared with gasoline, HCHO emission from M10 is greatly larger while CH3CHO is smaller. HCHO emission increases while CH3OH emission decreases with engine speed and tailpipe temperature. The three-way catalytic converter (TWC) can remove over 85% of CH3OH and CH3CHO emissions when it is lightened off. However, an unfamiliar phenomenon of minus HCHO conversion efficiency happens when engine speed is over 3500r/min, which infers that TWC may enhance HCHO emission rather than weaken it at high engine speeds.
What problem does this paper attempt to address?