Abstract:Electrostatic accelerometers have extremely high sensitivity and are ideal scientific instruments for measuring very weak acceleration. In particular, a single-sensitive-axis electrostatic accelerometer can be used for testing the equivalence principle in space. Sensitive-axis capacitances formed by axial electrodes and a cylindrical proof mass vary with the axial motion of the mass and are also affected by radial motion, which results in cross-axis coupling disturbances. A quantitative model is built to analyze the cross-axis coupling effect on the sensitive axis from the radial suspension loop, including a nonlinear model for large radial motion and a linear model for small radial motion. Frequency response simulation shows that the cross-axis coupling effect for a small signal case arises mostly in the high-frequency range. Experiments are carried out with a ground-based electrostatic accelerometer made of a single, non-rotating test cylinder, and in this case, the experimental results are utilized to verify the mathematical model. Cross-axis coupling for small signal perturbations is virtually removed if the equilibrium position of the proof mass is calibrated to the null position of the sensor cage. In addition, data post-processing can further attenuate the cross-axis coupling disturbances when dealing with large radial motion. The cross-axis coupling disturbances on both the position and the acceleration measurement signals in the sensitive axis are mostly removed in ground-based experiments. The proposed model and compensation can be extended to space equivalence principle instruments and other electrostatic accelerometers with a cylindrical proof mass.

Theoretical Investigation on Cross-Coupling Effect of Two-Dimensional Compound Pendulum Tiltmeter

Analysis of the Frequency-Dependent Vibration Rectification Error in Area-Variation-Based Capacitive MEMS Accelerometers.

Theoretical Study on Response of Two-Dimensional Compound Pendulum to Ground Vibration

Analysis of mechanical errors of planar capacitive sensor for two dimensional displacement measurement

Analysis and elimination of translation disturbance for patch effect measurement with a torsion pendulum

Investigation of Cross-Coupling Effect of a 3-DOF Magnetic Bearing Using Magnetic Circuit Method

A New Low-Frequency Active Vibration Isolation System

Tilt Active Vibration Isolation Using Vertical Pendulum and Piezoelectric Transducer with Parallel Controller

Modeling and Compensation of Cross-Axis Coupling in an Electrostatic Accelerometer for Testing the Equivalence Principle

Coupling effect of vibrations and residual electrostatic force in short-range gravitational experiments

Response of two-dimensional vertical pendulum tilt meter to crustal tilt

An Analytical Model for Studying the Structural Effects and Optimization of A Capacitive Tactile Sensor Array

Experiments on Active Precision Isolation with A Smart Conical Adapter

A Low-Frequency Vibration Insensitive Pendulum Bench Based on Translation-Tilt Compensation in Measuring the Performances of Inertial Sensors

Two-dimensional electromechanical-coupling modeling for out-of-plane bending vibration of cross-type beams

Performance measurements of an inertial sensor with a two-stage controlled torsion pendulum

A Biaxial Resonant Tilt Sensor with Two-Stage Microleverage Mechanisms

Cross-Coupling Coefficient Estimation of a Nano- g Accelerometer by Continuous Rotation Modulation on a Tilted Rate Table

Cross-Coupling Coefficient Estimation of a Nano-<italic>g</italic> Accelerometer by Continuous Rotation Modulation on a Tilted Rate Table

Location Effect and Adjustment Scheme of the Translation-Tilt Compensation Bench for Accelerometer Performance Investigation

Duplex Mode Tilt Measurements Based on a MEMS Biaxial Resonant Accelerometer