Abstract:Anaerobic ammonia oxidation (anammox) is an environmental-friendly biological nitrogen removal process, which has been developed as a promising technology in industrial wastewater treatment. However, anammox nitrogen removal under high saline conditions still faces many challenges. This study investigated the performance of anammox sludge under saline short-term shock and the strategy of rapid recovery. Salinity concentration, saline exposure time, and NaCl/Na2SO4 ratio were selected as three critical factors for short-term shock. The activity inhibition of anammox sludge were tested by using response surface methodology (RSM). Our results showed that, compared with the NaCl/Na2SO4 ratio, the salinity concentration and saline exposure time were the significant factor causing the anammox inhibition. The addition of glycine betaine (GB) in moderate amounts (0.1–5 mM) was found to help anammox to resist in relative low saline shock intensities (e.g., IC25 and IC50), with the activity retention rate of 94.7%. However, glycine betaine was not worked effectively under relatively high saline shock intensities (e.g., complete inhibition condition). Microbial community analysis revealed that Brocadiaceae accounted for only about 7.6%–13.2% at inhibited conditions. Interestingly, 16S rRNA analysis showed that the abundance of activated Brocadiaceae remarkably decreased with time after high-level saline shock. This tendency was consistent with the results of qPCR targeted hzsA gene. Finally, based on quorum sensing, the anammox activity was recovered to 93.5% of original sludge by adding 30% original sludge. The study realized the rapid recovery of anammox activity under complete inhibition, promoting the development and operation of salt-tolerant anammox process.

Modeling of completely autotrophic nitrogen removal process with salt and glycine betaine addition.

Enhanced Nitrogen Removal from Ammonium-Rich Wastewater Containing High Organic Contents by Coupling with Novel High-Rate ANAMMOX Granules Addition

Modeling granule-based completely autotrophic nitrogen removal over the nitrite (CANON) process in an SBR

Assessment of the positive effect of salinity on the nitrogen removal performance and microbial composition during the start-up of CANON process

Mitigating the detrimental effects of salt stress on anammox process: A comparison between glycine betaine and mannitol

Effect of High Salinity on Elemental Sulfur Autotrophic Partial Denitrification and Feasibility Evaluation of an Enhanced Strategy with Glycine Betaine Addition: Performance, Microorganisms, and Mechanisms

A Holistic Analysis of ANAMMOX Process in Response to Salinity: from Adaptation to Collapse

Anammox in a UASB Reactor Treating Saline Wastewater

Effect of Salinity on the Performance of an Anammox Reactor

Nitrogen Removal Through “candidatus Brocadia Sinica” Treating High-Salinity and Low-Temperature Wastewater with Glycine Addition: Enhanced Performance and Kinetics

[Effect of Sequential Biocatalyst Addition on Anammox Process].

Effects of alkalinity addition with different strategies on CANON process: Start‐up, performance, and microbial community

Impact of increasing sulfide addition on the nitrogen removal and microbial community of CANON process in membrane bioreactor

Bioaugmentation using salt-tolerant bacteria in a dual-stage process for high-salinity wastewater treatment: Performance, microbial community, and salt-tolerance mechanism

Modeling of Sulfur-Driven Autotrophic Denitrification Coupled with Anammox Process

Effects of salinity on the simultaneous anammox and denitrification process: performance, sludge morphology and shifts in microbial communities

Nitrogen removal from high-saline municipal wastewater via anammox-based process driven by both nitritation and denitratation

Saline short-term shock and rapid recovery on anammox performance

Enhanced Anaerobic Reduction of Nitrobenzene at High Salinity by Betaine Acting As Osmoprotectant and Regulator of Metabolism

Autotrophic Biological Nitrogen Removal from Saline Wastewater under Low DO

Inoculation of ANAMMOX Sludge for Ultra-Fast Start-Up of CANON Process and Performance Optimization