Abstract:Internal metallurgical defects and poor mechanical properties and surface quality of the formed parts are the most important challenges of metal micro-droplets deposition manufacturing technology. Lack of strong coalescence between neighboring droplets and the blocking effects of periodic ripples on the fusion process are major sources of abovementioned problems. To address this issue, a tungsten inert gas (TIG) welding arc was introduced to pre-melt the material below the droplet impacting location, thus, one droplet train will be deposited on a curved molten pool surface to fabricate deposited layers in an additive approach. In the present work, a numerical model based on the computational fluid dynamics (CFD) method was developed to investigate the dynamic behaviors of successive droplets' impact and coalescence on the molten pool created by a tilted TIG welding arc, and focuses on the effect of the offset distance between the impacting point of droplet and the longitudinal plane of molten pool on the deposition morphology and the impact-induced molten pool behaviors. The simulated tracks exhibit regular scaly shapes at different offset distances, which is validated against the corresponding experiments. The results indicated that as the lateral offset distance increases, the symmetric spreading and recoiling of the subsequent droplets on the pre-existing bead will be broken due to the inclined and curved solidification front morphologies, the inclined front morphologies are caused by the increased growth rate of the solidification front at the impact zone. With an increased lateral offset distance, the volume of the molten pool decreases, the width of the rear molten pool increases slightly. The calculated solidification parameters are found to be dependent of the offset distance, and vary significantly at the onset of solidification at different portions of the molten pool. The scientific findings provide useful insights for further researches of TIGassisted DDM.

Fusions Between Successive Deposition Droplets Impinging on a Moving Substrate Surface

The Fusion Process of Successive Droplets Impinging Onto a Substrate Surface

Numerical and Experimental Investigation of Molten Metal Droplet Deposition Applied to Rapid Prototyping

Experimental Investigation of the Sedimentation Behavior of Metal Droplets in Liquid–liquid Systems

Generation mechanism and suppression method of landing error of two successively deposited metal droplets caused by coalescence and solidification

Manufacturing of micro thin-walled metal parts by micro-droplet deposition

Microchannels Formed Using Metal Microdroplets

A Numerical Analysis on the Metal Droplets Impacting and Spreading out on the Substrate

Ultrasonic vibration micro-jet ejection for metal additive manufacture

Numerical Simulation and Validation of Metal Micro-droplet Deposition Forming

Exploring impact, spreading, and bonding dynamics in molten metal deposition for novel Drop-on-Demand printing

Voxelated Meniscus-Confined Electrodeposition of 3D Metallic Microstructures

Offset impacting of a liquid aluminum droplet train on a molten pool on a horizontally moving substrate during TIG-assisted droplet deposition manufacturing

Research on the Manufacturing of Electrical Power Fittings Based on Metal Droplet Deposition

NUMERICAL SIMULATION OF PILEUP PROCESS IN METAL MICRODROPLET DEPOSITION MANUFACTURE

Metal droplet printing of tube with high-quality inner surface via helical printing trajectory and soluble support

Feasibility of Multilayer Solid-State Deposition via Lateral Friction Surfacing for Metal Additive Manufacturing

Insights into the impact and solidification of metal droplets in ground-based investigation of droplet deposition 3D printing under microgravity

Printing regime for single metal microdroplet deposition in laser-induced forward transfer

Quantitatively characterizing the evolution of hole defects between overlapped aluminum droplets by a two-dimensional solidification model

Metal vapor micro-jet controls material redistribution in laser powder bed fusion additive manufacturing