Abstract:To address such challenges as an uncertain number of demagnetization poles of the permanent magnet synchronous motor (PMSM) and cases in which the fault cannot be located, this paper proposes a fault identification and location methodology based on the analysis of the motor stator current. First, the influence of the irreversible demagnetization of permanent magnets on the analytical model of the back electromotive force (Back-EMF) of the rotor in a single motor stator slot is analyzed. Moreover, considering the topology of the motor, the influence of the demagnetization fault on the stator phase current and branch current is analyzed. Since the stator phase currents cannot diagnose the partial demagnetization faults of PMSM with some topological structures, the stator branch current is selected as the signal for the identification and localization of the demagnetization fault. Secondly, the demagnetization fault diagnosis and mode recognition of the motor are carried out through the amplitude of the real-time branch current and the harmonic components of the PMSM. A sample database of demagnetization faults is established through calculation and normalization of the residual value of the stator branch current and the branch current of the healthy motor after demagnetization in one pole order. The fault threshold is obtained by analyzing the residual of the branch current of uniform demagnetization and the Pearson correlation coefficient of the fault sample database. Then, the correlation coefficient between the real-time branch current residual value of PMSM and the fault sample database is analyzed, and the number of demagnetization poles and the fault location are determined by the number and location of the calculated correlation coefficient exceeding the threshold. Finally, the feasibility and effectiveness of the proposed method are verified by the finite element analysis (FEA) results.

Features Analysis of Partial Demagnetization Faults in the 6-Phase PM Synchronous Generator with Rectifier Load System

Influence of Healthy Winding Group Current on Three-Phase Short-Circuit and Demagnetization in Dual Three-Phase Surface-Mounted PM Machines

A Sinusoidal Current Control Method for SPMSM Considering Uneven Demagnetization Fault

Analytical On-Load Subdomain Field Model of Permanent-Magnet Vernier Machines.

Analysis and Mitigation of Fault-Induced Electromagnetic Force Effect on PM Modules in Integral-Slot Wind Generators

The Electromagnetic Field Analysis of Permanent Magnet Synchronous Generator Based on ANSYS

Thermal Analysis of Internal Short-Circuit Faults in Stator Windings of Multiphase Permanent Magnet Synchronous Generator with Rectifier-load System

Uneven Demagnetization Fault Diagnosis in Dual Three-Phase Permanent Magnet Machines Based on Electrical Signal Difference

Investigation of Postdemagnetization Unbalanced Magnetic Force in PM Machines Considering Short-Circuit Faults

Influence of Dimensional Parameters on Three-Phase Short Circuit and Demagnetization in Surface-Mounted PM Machines

Influence of Load Characteristics on Three-Phase Short Circuit and Demagnetization of Surface-Mounted PM Synchronous Motor

Finite Element Simulation on Irreversible Demagnetization of Permanent Magnet Synchronous Generator

Investigation of Post-Demagnetization Torque Ripple in Fractional-Slot Surface-Mounted PM Wind Power Generators after Short Circuit Faults

Research and Application of Intelligent Diagnosis Technology in Permanent Magnet Generator for Stress Demagnetization Fault

RLS-Based Algorithm for Detecting Partial Demagnetization under Both Stationary and Nonstationary Conditions

Demagnetization Fault Diagnosis for Magnetically Suspended PMSM Using Rotor Displacement Signals

Incipient Fault Detection and Condition Assessment in DFIGs Based on External Leakage Flux Sensing and Modified Multiscale Poincare Plots Analysis

Demagnetization Fault Detection and Location in PMSM Based on Correlation Coefficient of Branch Current Signals

A Comparative Study on Two Outer Rotor PMSMs for In-Wheel Direct Drive under Short-Circuit Faults

An Online Monitoring Technique for Partial Demagnetization Monitoring of Permanent Magnet Machines Based on Intermittent Short-circuit

An Analytical Model of Unbalanced Magnetic Force in Fractional-Slot Surface-Mounted Permanent Magnet Machines