Abstract:Arsenite (As(III)) is more toxic and more difficult to remove from water than arsenate (As(V)). As there is no simple treatment for the efficient removal of As(III), an oxidation step is always necessary to achieve higher removal. However, this leads to a complicated operation and is not cost-effective. To overcome these disadvantage, a novel Fe–Mn binary oxide material which combined the oxidation property of manganese dioxide and the high adsorption features to As(V) of iron oxides, were developed from low cost materials using a simultaneous oxidation and coprecipitation method. The adsorbent was characterized by BET surface areas measurement, powder XRD, SEM, and XPS. The results showed that prepared Fe–Mn binary oxide with a high surface area (265m2g-1) was amorphous. Iron and manganese existed mainly in the oxidation state +III and IV, respectively. Laboratory experiments were carried out to investigate adsorption kinetics, adsorption capacity of the adsorbent and the effect of solution pH values on arsenic removal. Batch experimental results showed that the adsorbent could completely oxidize As(III) to As(V) and was effective for both As(V) and As(III) removal, particularly the As(III). The maximal adsorption capacities of As(V) and As(III) were 0.93mmolg-1 and 1.77mmolg-1, respectively. The results compare favorably with those obtained using other adsorbent. The effects of anions such as SO42-, PO43-, SiO32-, CO32- and humic acid (HA), which possibly exist in natural water, on As(III) removal were also investigated. The results indicated that phosphate was the greatest competitor with arsenic for adsorptive sites on the adsorbent. The presence of sulfate and HA had no significant effect on arsenic removal. The high uptake capability of the Fe–Mn binary oxide makes it potentially attractive adsorbent for the removal of As(III) from aqueous solution.

Synthesis and Evaluation of Mn-Fe Binary Oxide Adsorbents for Arsenic Removal

Preparation and Evaluation of a Novel Fe–Mn Binary Oxide Adsorbent for Effective Arsenite Removal

Preparation of Fe-Mn bimetal oxide adsorbent and its adsorption characteristics of arsenic

Adsorption Kinetic Properties of As(III) on Synthetic Nano Fe-Mn Binary Oxides

Adsorption Behavior and Mechanism of Arsenate at Fe-Mn Binary Oxide/Water Interface

Synergy of Mn-Fe-Al and Reconstruction of Chemisorption & Physisorption in Arsenic Removal

Respective Role Of Fe And Mn Oxide Contents For Arsenic Sorption In Iron And Manganese Binary Oxide: An X-Ray Absorption Spectroscopy Investigation

Adsorption Behavior and Mechanism of Arsenic on Mesoporous Silica Modified by Iron-Manganese Binary Oxide (Femnox/sba-15) from Aqueous Systems.

Preparation of a spindle -MnO<sub>2</sub>@Fe/Co-MOF-74 for effective adsorption of arsenic from water

Redox Transformation of Arsenic by Magnetic Thin-Film MnO2 Nanosheet-Coated Flowerlike Fe3O4 Nanocomposites

Preparation of a spindle δ-MnO2@Fe/Co-MOF-74 for effective adsorption of arsenic from water

Substitution-Mediated Enhanced Adsorption of Low Concentration As (V) from Water by Ordered Mesoporous MnxFe3-xO4 Microspheres

Removal of Trace Arsenic to below Drinking Water Standards Using a Mn–Fe Binary Oxide

Arsenate Uptake and Arsenite Simultaneous Sorption and Oxidation by Fe-Mn Binary Oxides: Influence of Mn/Fe Ratio, Ph, Ca2+, and Humic Acid

Removal Mechanism of As(III) by a Novel Fe-Mn Binary Oxide Adsorbent: Oxidation and Sorption.

Adsorption-Oxidation Of Arsenite By Nano-Iron-Manganese Binary Oxide In Synthesized Groundwater

Etching Synthesis of Iron Oxide Nanoparticles for Adsorption of Arsenic from Water

Using Fe–Mn Binary Oxide Three-Dimensional Nanostructure to Remove Arsenic from Aqueous Systems

Ordered Mesoporous Mno2 As A Synergetic Adsorbent For Effective Arsenic(Iii) Removal

As(III) Adsorption on Fe-Mn Binary Oxides: Are Fe and Mn Oxides Synergistic or Antagonistic for Arsenic Removal?

Adsorption Effect and Mechanism of Aqueous Arsenic on FeMnNi-LDHs