Abstract:For the research on real-time accurate testing technology for the explosion point spatial coordinate of munitions, its currently commonly used methods such as acoustic–electric detection or high-speed imaging are limited by the field conditions, response rate, cost, and other factors. In this paper, a method of spatial coordinate testing for the explosion point based on a 2D PSD (position-sensitive detector) intersection is proposed, which has the advantages of a faster response, better real-time performance, and a lower cost. Firstly, a mathematical model of the spatial coordinate testing system was constructed, and an error propagation model for structural parameters was developed. The influence of the position of the optical axes' intersection as well as the azimuth angle and pitch angle on the test accuracy of the system was simulated and analyzed, thus obtaining the distribution and variation trend of the overall error propagation coefficient of the system. Finally, experiments were designed to obtain the test error of the system for validation. The results show that the system test accuracy is high when the azimuth angle is 20°–50°, the overall error propagation coefficient does not exceed 48.80, and the average test error is 56.17 mm. When the pitch angle is −2.5°–2.5°, the system has a higher test accuracy, with the overall error propagation coefficient not exceeding 44.82, and the average test error is 41.87 mm. The test accuracy of the system is higher when the position of the optical axes' intersection is chosen to make sure that explosion points fall in the region of the negative half-axis of the Zw-axis of the world coordinate system, with an overall error propagation coefficient of less than 44.78 and an average test error of 73.38 mm. It is shown that a reasonable selection of system structure parameters can significantly improve the system test accuracy and optimize the system deployment mode under the long-distance field conditions so as to improve the deployment efficiency.

Accuracy Analysis and Optimization of Infrared Guidance Test Device

Error impact analysis and experimental research for absolute testing of spherical surfaces

Accuracy Analysis for Digital Boresighting of Aircraft Gun

Test of Infrared Search and Track System

Research Onmethods of Missile Guidance Precision Analysis

The Design Study of the Precision Measuring Analysis Instrument of the Missile Weapon System

Design and Simulation of an Optimal Missile Trajectory with Constraints of Impact Time and Impact Angle

Design and Optimization of Wavy Trajectory for Ballistic Missiles

Optimum Design on the Section of Missile for Orbit and Attitude Control

Error Analysis for Guidance Control Parameters of Air to Surface SAR Missile

Influence Analysis of Tracking Seeker Component Imperfections to High Off-boresight Launch Missile

Error Analysis and Optimization of Structural Parameters of Spatial Coordinate Testing System Based on Position-Sensitive Detector

Study on Infrared Air?to?Air Missile Guidance Accuracy Affected by Complicated Environment

Optimization Design Method of a New Stabilized Platform Based on Missile-borne Semi-Strap-down Inertial Navigation System

Accuracy Test and Analysis for Infrared Search and Track System

Accuracy Analysis of Surface Figure Fitting Based on Opto-Mechanical-thermal Technology

Three-dimensional Guidance and Control for Missile

A Measuring System of Inertia Moment of Missile and Its Error Analysis

General Design Trade-Offs for a Precise Terminal Guidance System

Error Modeling of Hardware-in-the-Loop Simulation System and Its Influence Analysis for a Certain Missile.

Investigation and simulation of optimal midcourse guidance for air-to-ground missiles