Abstract:TiO2 surfaces modified with noble metal nanoparticles have been found to effectively reduce the photogenerated carrier recombination rate and significantly extend the light absorption properties of TiO2, thereby greatly increasing its photocatalytic activity. In this paper, highly ordered, double sided TiO2 nanotube arrays were prepared using an anodic oxidation method in a home-made reactor using glycerol/water (volume ratio 2:1) and NH4F (0.25 mol/L) as the electrolyte, titanium plates (10 cm x 2 cm x 0.5 mm) as the anode and graphite as the cathode at a constant voltage of 25 V. After a 2-h reaction, anatase TiO2 nanotubes were obtained upon calcination at 450 degrees C for 4 h. The Ag nanoparticles on the surfaces of the TiO2 were prepared via ultrasonic atomization-ultraviolet light reduction. First, a silver nitrate solution was sputtered into small droplets under ultrasonication. Then, the Ag+ droplets were reduced to Ag nanoparticles. The surface morphologies, structures and elemental compositions were characterized using SEM, EDS, XRD and XPS. The photocatalytic activities were determined in acetic acid solutions (40-200 mg/L), and a mathematical model for catalytic degradation was established based on a hyperbolic model. The SEM results showed that the diameters of the as-prepared Ag/TiO2 are approximately 100 nm and that the lengths are approximately 1.8 mu m. The XRD crystal structure analysis shows that the anatase phase of the TiO2 does not change during the Ag modification, and there was a peak from Ag (2 2 0). The XPS determined that the Ag atom percentage was 1.11%. The degradation of acetic acid indicated that Ag/TiO2 has a higher photocatalytic activity than the undoped TiO2. (C) 2014 Elsevier B.V. All rights reserved.

Preparation of Ag Nanoparticle Surface Modified Tio2 Nanotube Arrays and Establishment of A Catalytic Kinetic Model

Fabrication of Ag/TiO2 Nanotube Array with Enhanced Photo-Catalytic Degradation of Aqueous Organic Pollutant

TiO2 nanotube arrays prepared by anodic oxidation method

Controllable Synthesis Of Silver-Nanoparticle-Modified Tio2 Nanotube Arrays For Enhancing Photoelectrochemical Performance

Preparation and Characterization of TiO<SUB>2</SUB> Nanotube Arrays by Anodic Oxidation Method: Preparation and Characterization of TiO<SUB>2</SUB> Nanotube Arrays by Anodic Oxidation Method

TiO2 Modified with Ag Nanoparticles Synthesized Via Ultrasonic Atomization-Uv Reduction and the Use of Kinetic Models to Determine the Acetic Acid Photocatalytic Degradation

Electrodeposition Preparation of Ag Nanoparticles Loaded TiO2 Nanotube Arrays with Enhanced Photocatalytic Performance

Simple Synthesis of Pt/TiO2 Nanotube Arrays with High Activity and Stability

Preparation and Ag-modification of anodized titania nanotube array and its photocatalytic activity

Preparation and Photocatalytic Activity of Silver Doped TiO<sub>2</sub> Nanotubes

Preparation and Photocatalytic Activity of Silver Doped TiO2 Nanotubes

Preparation of TiO2 Nanotube Photocatalyst by Anodization and Improvement of Photocatalytic Performance

Preparation and Characterization of Ag/TiO2 Nanoparticle Catalyst and Its Photocatalytic Activity

Structural Manipulation of the Photocatalytic Activity of Tio2 Nanotube Arrays

Synthesis and Photoelectrochemical Properties of Self-Organized Anodic TiO2 Nanotube Arrays

Facile Fabrication of Well-Dispersed Silver Nanoparticles Loading on TiO2 Nanotube Arrays by Electrodeposition

Synthesis and Photoelectrochemical Properties of Self-Organized Anodic TiO<sub>2</sub> Nanotube Arrays

Synthesis and investigation of TiO2 nanotube arrays prepared by anodization and their photocatalytic activity

Electrochemical Fabrication and Formation Mechanism of Tio2 Nanotube Arrays on Metallic Titanium Surface

Controllable Preparation of TiO2 Nanotube Arrays on Ti Foil Substrates

TiO2 Nanotube Arrays Prepared by Electrochemical Anodization Technique and Their Photoelectrochemical Properties