Response of Lean Premixed Swirl Tubular Flame to Acoustic Perturbations

Kang Ma,Xiao Yu,Xiaoyao Zhao,Xinyan Li,Shuiqing Li,Dan Zhao,Baolu Shi
DOI: https://doi.org/10.1016/j.expthermflusci.2020.110199
IF: 3.2
2020-01-01
Experimental Thermal and Fluid Science
Abstract:This study experimentally examined the response of a lean premixed methane/air swirl tubular flame to the longitudinal acoustic perturbations. Experiments were conducted by varying the acoustic frequency (f(0)), acoustic power (P-0) and inlet air flow rate (Q(A)) to systematically study the acoustic-excited flame dynamics, including the flame stability, flame structure, heat release rate and acoustic pressure fluctuations. The results demonstrated that the lean tubular flame was much sensitive to longitudinal perturbations below 210 Hz. Even at low power of P-0, the flame was forced to oscillate intensively when the perturbation was operated in two discontinuous frequency ranges of f(0) = 150-200 and f(0) = 50-100 Hz, while a weakened oscillation regime was observed in the middle range of f(0) = 100-150 Hz; a lower frequency (less than 50 Hz) would extinguish the flame. An increase in P-0 intensified the flame oscillation under the perturbations of 50-100 Hz, and even resulted in flame lift-off and blow off with f(0) between 150 and 200 Hz. In comparison to f(0) and P-0, the effects of air flow rate (Q(A)) seemed to be weaker. The proper orthogonal decomposition (POD) analysis was performed to interpret the contributions from the mean mode and fluctuating axial and circumferential modes that led to combustion instability. It was found that as the energy fraction of the axial mode exceeded 5.0%, the flame lift-off appeared in the lean swirl tubular configuration.
What problem does this paper attempt to address?