N-Heterocyclic Carbene/lewis Acid-Mediated Ring-Opening Polymerization of Propylene Oxide. Part 1: Triisobutylaluminum As an Efficient Controlling Agent

Qilei Song,Junpeng Zhao,Guangzhao Zhang,Daniel Taton,Frederic Peruch,Stephane Carlotti
DOI: https://doi.org/10.1016/j.eurpolymj.2020.109819
IF: 6
2020-01-01
European Polymer Journal
Abstract:Ring-opening polymerization (ROP) of propylene oxide (PO) is achieved at 25 degrees C either in bulk or in solution, using N-heterocyclic carbenes (NHCs) and triisobutylaluminum (i-Bu3Al) as a bicomponent catalytic system. Transfer to monomer was not observed and poly(propylene oxide)s with predictable molar masses up to 60 000 g.mol(-1) and low dispersities were obtained. In presence/absence of an alcohol as the initiator, the polymerization of PO follows anionic or zwitterionic ROP mechanisms, respectively. The addition of the Lewis acid strongly improves the efficiency of NHCs for the polymerization of substituted epoxides. It is established that i-Bu3Al is involved both in the formation of an initiating/propagating complex of moderate basicity/nucleophilicity and in the coordination of PO, enabling the activation of the monomer towards the complexed nucleophilic active species. Block copolyethers are also prepared by PPO chain extension experiments. All (co) polyethers were thoroughly characterized by H-1 NMR spectroscopy, SEC and MALDI-TOF mass spectrometry as means to prove the control and benefit of this NHC approach for epoxides ROP.
What problem does this paper attempt to address?