Abstract:A systematic study of the physical and mechanical processes of landslide development and evolution is important for forecasting, early warning, and prevention of landslide hazards. In the absence of on-site monitoring data, seismic networks can be employed to continuously record ground seismicity generated during landslides. However, landslide seismic signals are relatively weak and inevitably affected by noise interference. Furthermore, systematic characterization and reconstruction of the landslide evolution process remain poorly reported. An evaluation method to recognize landslide events based on seismic signal characteristics is therefore important. This study analyzes the 2019 "7.23" Shuicheng landslide based on data from nearby seismic stations. A landslide seismic signal recognition method is developed based on short-time Fourier transform (STFT) and band-pass filter (BP-filter) analysis. Data from 14 stations near the landslide were reviewed and the landslide data from one station was selected for analysis. The landslide seismic signal was noise-attenuated by using the empirical mode decomposition (EMD) and BP-filter methods. Fast Fourier transform (FFT), STFT, and power spectral density analyses were applied to the landslide seismic signal with higher signal-to-noise ratio (SNR) to obtain the time–frequency signal characteristics of the landslide process. Finally, combined with landslide field survey data, the dynamic process of the landslide was reconstructed based on the seismic signal, and the landslide was divided into four stages: the fracture-transition stage, the accelerated initiation stage, the bifurcation-scraping stage, and the deposition stage. The dynamic characteristics of each stage of the landslide are presented. The results indicate that the initial fracture point of the landslide is located between the bottom of the sliding source area and the top of the acceleration zone, not as traditionally thought, at the top of the sliding source area; this would be difficult to determine through field survey and analysis only. These results provide theoretical guidance for the study of seismic signal extraction, identification of landslide dynamic parameters, and characterization and reconstruction of landslide processes.

Landslide Reconstruction Using Seismic Signal Characteristics and Numerical Simulations: Case Study of the 2017 “6.24” Xinmo Landslide

Seismic signal recognition and interpretation of the 2019 “7.23” Shuicheng landslide by seismogram stations

Seismic Signal Characteristics and Numerical Modeling Analysis of the Xinmo Landslide

Combining Seismic Signal Dynamic Inversion and Numerical Modeling Improves Landslide Process Reconstruction

Link Between the Landslides and the Generated Seismic Signals: Dynamic Inversion and Numerical Simulation

Application of Combined Electrical Resistivity Tomography (ERT) and Seismic Refraction Tomography (SRT) Methods to Investigate Xiaoshan District Landslide Site: Hangzhou, China

Physics-based large-deformation analysis of coseismic landslides: A multiscale 3D SEM-MPM framework with application to the Hongshiyan landslide

Seismic signal characteristics and interpretation of the 2020 “6.17” Danba landslide dam failure hazard chain process

Application of Logistic Regression Model for Hazard Assessment of Landslides Caused by the 2012 Yiliang Ms 5.7 Earthquake in Yunnan Province, China

Investigation of 20 August 2019 Catastrophic Debris Flows Triggered by Extreme Rainstorms Near Epicentre of Wenchuan Earthquake

An Integrated SEM-Newmark Model for Physics-Based Regional Coseismic Landslide Assessment

DISCRETE ELEMENT MODELING AND SIMULATION OF 3-DIMEN-SIONAL LARGE-SCALE LANDSLIDE-TAKING XINMOCUN LANDSLIDE AS AN EXAMPLE

Dynamic Modeling of Meiping Landslide Process

Some Considerations on the Use of Numerical Methods to Simulate Past Landslides and Possible New Failures: the Case of the Recent Xinmo Landslide (sichuan, China)

Numerical modeling of the Mount Meager landslide constrained by its force history derived from seismic data

Geostatistical modeling to capture seismic-shaking patterns from earthquake-induced landslides

Numerical investigation of the landslide-debris flow transformation process considering topographic and entrainment effects: a case study

Dynamic process analysis for the initiation and movement of the Donghekou landslide-debris flow triggered by the Wenchuan earthquake

Characterization of pre- and post-failure deformation and evolution of the Shanyang landslide using multi-temporal remote sensing data

Seismic-induced surficial failure of cohesive slopes using three-dimensional limit analysis: A case study of the Wangjiayan landslide in Beichuan, China

Reconstructing the Dynamic Processes of the Taimali Landslide in Taiwan Using the Waveform Inversion Method