Diffusion-weighted imaging in malignant pulmonary tumors and solid benign lesions
LIU Haidong,YU Tielian,LIU Ying,YE Ning
2010-01-01
Abstract:Objective To evaluate the feasibility of diffusion-weighted imaging(DWI) with array spatial sensitivity encoding technique(ASSET) and phased-array coil in malignant pulmonary tumors and solid benign lesions,and to optimalize imaging parameters.Methods Twelve benign lesions and fifty malignant pulmonary lesions with sixty-six lesions were enrolled in this study.Twelve of them with twelve lesions constituted group one,who underwent DWI using 1.5 T MR scanner with four different scan methods.The scan methods consisted of method A using ASSET,free breathing and four NEX,method B using ASSET,free breathing and one NEX,method C using ASSET,breath-hold and one NEX,and method D using conventional DWI without ASSET,breath-hold and one NEX.Group two was composed of all sixty-two patients,they all underwent DWI with different b values(200,300,500,700,1 000 s/mm2).Results In group one,signal to noise ratio(SNR) and contrast to noise ratio(CNR) of method A were best compared to other methods,and the difference had statistical significance(P=0.000,P=0.000).In group two,with b values changing from low to high,SNR of DWI images was 53.3,45.9,35.7,26.9,21.4 and CNR was 3.77,4.22,4.36,3.77,2.90 respectively.The SNR differed significantly among different b values(P<0.001),but CNR did not(P>0.05).ADC values of malignant pulmonary tumors and solid benign lesions reduced gradually with b value increasing,and the differences had statistical significance(P<0.001).By ROC curve analysis,the ADC values obtained from each b value were profit for differentiation between benign and malignant tumors.The area under ROC curve with b value of 500 s/mm2 was the largest.The optimal ADC threshold value of 1.400×10-3 mm2/s yielded sensitivity 83.3% and specificity 74.1%.Conclusion DWI examination with phased-array body coil and ASSET is feasible for assessing pulmonary malignant tumors and solid benign lesions,and the optimal b value is 500 s/mm2.