Abstract:Photoelectrochemical (PEC) water splitting serves as one of the promising approaches for producing clean and renewable energy, and their solar–hydrogen energy conversion efficiency depends on the interfacial charge separation and carrier mobility. Herein, we report an effective strategy to promote the PEC performance by fabricating a WO3 photoanode rich in oxygen vacancies (Ov) modified by NiFe-based layered double hydroxide (LDH). When WO3–Ov/NiFe-LDH is used as a photoanode, the maximum photocurrent density at 1.8 V versus RHE has been significantly enhanced to 2.58 mA·cm–2, which is 4.3 times higher than that of WO3. In addition, analogues were studied in controlled experiments without Ov, which further demonstrated that the synergistic effect of NiFe-LDH and Ov resulted in increased carrier concentration and driving force. According to electrical impedance spectroscopy, X-ray photoelectron spectroscopy, and Mott–Schottky analysis, the built-in electronic field in WO3 homojunction, along with the accelerated hole capture by the NiFe-LDH cocatalyst contributes to the improved charge separation and transport in the WO3–Ov/NiFe-LDH electrode. This work proposes an efficient and valuable strategy for designing the structure of WO3-based photoelectrodes.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.langmuir.1c00638?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.langmuir.1c00638</a>.O 1s XPS spectrum of WO3; UV–vis spectra and Tauc plots of WO3, WO3–Ov, and WO3–Ov/NiFe-LDH photoanodes; PL spectra and Mott–Schottky plots of WO3, WO3–Ov, and WO3–Ov/NiFe-LDH photoanodes; and comparison of typical WO3-based photoanodes for PEC water splitting (<a class="ext-link" href="/doi/suppl/10.1021/acs.langmuir.1c00638/suppl_file/la1c00638_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Metal-Reduced WO3–x Electrodes with Tunable Plasmonic Resonance for Enhanced Photoelectrochemical Water Splitting

WO3@α‐Fe2O3 Heterojunction Arrays with Improved Photoelectrochemical Behavior for Neutral Ph Water Splitting

Integrating transition metal phosphide catalysts on WO3 photoanodes enabling robust photoelectrocatalytic water oxidation

Perovskite Oxide Based Electrodes for High‐Performance Photoelectrochemical Water Splitting

Large-Scale Tunable 3D Self-Supporting WO3 Micro-Nano Architectures As Direct Photoanodes for Efficient Photoelectrochemical Water Splitting.

A natural molecule-driven organometallic conformal overlayer for high efficiency photoelectrochemical water splitting

Efficient Photoelectrochemical Water Splitting and Impedance Analysis of WO3−x Nanoflake Electrodes

Novel synthesis of reduced PdO-WO 3 hybrids for enhanced photoelectrochemical water splitting

Interface Manipulation to Improve Plasmon‐Coupled Photoelectrochemical Water Splitting on Α‐fe2o3 Photoanodes

Oxygen Vacancy-Enhanced Photoelectrochemical Water Splitting of WO 3 /NiFe-Layered Double Hydroxide Photoanodes

Facile one-step synthesis of a WO 3 /ZnWO 4 heterojunction modified using ZnFe LDH enhances the PEC water splitting efficiency

General In Situ Photoactivation Route with IPCE over 80% toward CdS Photoanodes for Photoelectrochemical Applications

High-Voltage Etching-Induced Terrace-like WO 3 Photoanode for Efficient Photoelectrochemical Water Splitting

Design of Sandwich-Structured ZnO/ZnS/Au Photoanode for Enhanced Efficiency of Photoelectrochemical Wate Splitting

Oxygen Vacancy-Enhanced Photoelectrochemical Water Splitting of WO3/NiFe-Layered Double Hydroxide Photoanodes.

Plasmon-promoted electrocatalytic water splitting on metal-semiconductor nanocomposites: the interfacial charge transfer and the real catalytic sites

Material Design and Surface/Interface Engineering of Photoelectrodes for Solar Water Splitting

Engineering Single-Atomic Ni-N4-O Sites on Semiconductor Photoanodes for High-Performance Photoelectrochemical Water Splitting

A semiconductor-electrocatalyst nano interface constructed for successive photoelectrochemical water oxidation

One-Step Rapid and Scalable Flame Synthesis of Efficient WO3 Photoanodes for Water Splitting.

Efficient Acidic Photoelectrochemical Water Splitting Enabled by Ru Single Atoms Anchored on Hematite Photoanodes