Abstract:This article establishes a finite element method (FEM) model to characterize and classify the chip morphologies of Inconel 718, which tends to form shear localized chips. Orthogonal cutting simulations in a wide range of speeds with three uncut chip thicknesses are carried out to model the plastic deformation of Inconel 718 and thus the formation of the serrated chips by utilizing the Johnson-Cook (JC) constitutive law with the criterion of the accumulated plastic strain. Evolution trends of the chip deformation results are of the main interest and focus is placed on the chip segmentation. Simulation results show that Inconel 718 exhibits a chip pattern transition from the continuously smooth form to the regularly serrated form with the increase of cutting speed. However, the disappearance of chip serration is also observed at still higher cutting speeds. The primary shear angle and the segment inclination finally reach the same asymptotic value of 45 ∘ . The shear band spacing drops significantly before the two plateau regions are achieved. Apart from these, the scatter plot of specific cutting force tends to be a concave shape, while the scatter plot of chip segmentation degree tends to be a convex shape. Meanwhile, the chip thickness ratio approaches an asymptotic value, and the average velocity of chip sliding on the tool rake face almost equals the cutting speed. At the same time, the simulation results are compared to the results by experiments or simulations in the published literatures. Moreover, the FEM model is validated by comparing the chip morphologies from the experiments and the simulations, respectively. The proposed work is fundamental for not only increasing understandings of the metal cutting process of Inconel 718, but also hypothetically providing a framework of the chip generation under the cutting speed from low to high range.

Experimental and Finite Element Analysis of the Formation Mechanism of Serrated Chips of Nickel-Based Superalloy Inconel 718

The Finite Element Analysis Of Serrated Chip Formation In High-Speed Cuffing Auto Panel Dies

Simulation of Chip Formation in High-Speed Hard Machining

Chip Formation Mechanism of Inconel 718: A Review of Models and Approaches

Finite Element Simulation of Serrated Chip Formation in High-speed Milling of A lloy Cast Iron

Simulation of the Chip Morphology Together with Its Evolution in Machining of Inconel 718 by Considering Widely Spread Cutting Speed

Milling Mechanism and Chattering Stability of Nickel-Based Superalloy Inconel 718

A FEM Study on Chip Formation in Orthogonal Turning Nickel-Based Superalloy GH80A

The effect of chip formation on the cutting force and tool wear in high-speed milling Inconel 718

A FEM and Experiment Study on High Speed Machining of Nickel-Based Superalloy GH4169

Determination of the Yield Strength and the Energy Distribution in the Milling of Inconel 718 Considering Fracture Toughness

Finite Element Simulation of Surface Residual Stress in Micro-milling Inconel 718

Finite element simulation of the formation process of a serrated chip in high-speed cutting

Serrated chip characteristics and formation mechanism in high-speed machining of selective laser melted Ti6Al4V alloys

Finite Element Analysis Of The Serrated Chip Formation During Machining Ti6al4v Alloy

Mechanisms and FEM Simulation of Chip Formation in Orthogonal Cutting In-Situ TiB2/7050Al MMC

Effect of cutting conditions on the serrated chip formation in high-speed cutting

EXPERIMENTAL INVESTIGATION ON SURFACE INTEGRITY OF END MILLING NICKEL-BASED ALLOY— INCONEL 718

A simulation of chip formation mechanism in elliptical vibration assisted cutting of nickel-based superalloy Inconel 718

Study on the Formation Mechanism of Serrated Chips in the Cutting Process of Powder Metallurgy Superalloys Based on a Modified J–C Constitutive Relation Simulation Model

Study on chip formation and surface integrity of nickel-based superalloy Inconel 718 by laser assisted micro-cutting