Abstract:In the field of non-destructive evaluation (NDE) of solid metal materials, it has been a challenge to detect surface and internal defects simultaneously by using a single physical mechanism technique. Conventionally, different testing techniques, in which each one is particularly sensitive to a certain type of defect, are employed to gain full defect information. However, a separated testing method is always a time-consuming and laborious work. Here, we report a magnetoelectric-ultrasonic hybrid transducer and multimodal system for quantitative NDE of metal, which integrates a magnetoelectric composite wrapped with a coil for generating alternating current field and simultaneously measuring magnetic abnormal of surface defects (referred to as ME-ACFM) and a dual-piezoceramic ultrasonic transducer (DP-UT) for generating acoustic pulses and detecting the echo signal of internal defects, respectively. A bipulse signal with different pulse widths is used for excitation of the hybrid transducer, in which one is corresponded to the resonant frequencies of 5 MHz for DP-UT, and another to 122 kHz for ME-ACFM. The huge difference between two resonant frequencies is helpful for restraining signal interference each other. Experimental investigations show that when scanning the tested specimens (standard steel No.45 and aluminum plates), the surface and internal defects information can be obtained simultaneously almost without a dead zone. The surface defect resolutions of 0.1 mm width and 0.1 mm depth, and the inside defect resolution of 2 mm blind hole are obtained; the experimental errors for surface defect (crack) depth up to 5 mm are around 5 %; while experimental errors for ultrasonic depth measurement (with a blind zone of 1.25 mm) is less than 0.63 mm. The proposed hybrid transducer and multimodal system open up a new way for designing multi-physical mechanism based NDEs.

Identifying Surface Defect Opening Profiles Based on the Uniform Magnetic Field Distortion

Nondestructive Evaluation of Special Defects Based on Ultrasound Metasurface

An Opening Profile Recognition Method for Magnetic Flux Leakage Signals of Defect

A Defect Opening Profile Estimation Method Based on the Right-Angle Characteristic of Vertical Component of MFL Signal

A Characteristic Approximation Approach to Defect Opening Profile Recognition in Magnetic Flux Leakage Detection

Surface defects evaluation system based on electromagnetic model simulation and inverse-recognition calibration method

A 3-D Imaging Method for Local Shallow Defects on the Surface of Ferromagnetic Materials

An Improved MFL Method Fusing Multi-Space Magnetic Field Information for The Surface Defect Inspecting

A Defect Visualization Method Based on ACFM Signals Obtained by a Uniaxial TMR Sensor

A Novel Defect Quantification Method Utilizing Multi-Sensor Magnetic Flux Leakage Signal Fusion

Nonlinear Analytical Modelling for Surface-Mounted Permanent Magnet Motors with Magnet Defect Fault

A 3-D Pseudo Magnetic Flux Leakage (PMFL) Signal Processing Technique for Defect Imaging

Surface and back-side defects identification combined with magnetic flux leakage and boundary magnetic perturbation

A New Method to Evaluate Surface Defects with an Electromagnetic Acoustic Transducer

Quantitative Nondestructive Estimation of Deep Defects in Conductive Structures

Uneven Demagnetization Fault Diagnosis in Dual Three-Phase Permanent Magnet Machines Based on Electrical Signal Difference

A flexible permanent magnetic field perturbation testing probe based on through-slot Flexible Magnet Sheet

A magnetoelectric-ultrasonic multimodal system for synchronous NDE of surface and internal defects in metal

Physical coupling fusion sensing of MFL-EMAT for synchronous surface and internal defects inspection

Evaluation of Depth Size Based on Layered Magnetization by Double-Sided Scanning for Internal Defects

Nondestructive Testing Method for Internal Defects in Ferromagnetic Materials under Weak Bias Magnetization