Abstract:Despite many applications in the process industries, the suspension of floating particles in aerated stirred tanks has received little attention. The critical just drawdown agitator speed for different concentrations of floating particles, gas holdup and shaft power have been measured in a vessel of 0.476m diameter with four baffles and dished base. The aspect ratio of the liquid in the tank is 1.8. Five agitator configurations, each with three impellers on a single shaft, were used in the experiments. Two impeller designs were used, a deep hollow blade (semi-ellipse) disk turbine (HEDT) and a 4-wide-blade hydrofoil impeller, the latter in either upward-pumping (WHU) or downward-pumping (WHD) mode. Polypropylene (PP) particles, 3 or 4mm in size and density 900kg/m3, were used in the suspension experiments. Results show that these solids have little effect on the relative power demand (RPD, ratio of gassed power demand to that when ungassed, i.e., RPD=PG/PU). Agitators using the radial dispersing HEDT as the bottom impeller have a flatter RPD, than those when an up or down pumping hydrofoil is at the bottom. However, gas holdup decreases with increasing solid concentration. Among the five different impeller combinations, a downward pumping top impeller has a significantly higher just drawdown agitation speed and power consumption, so the WHD mode is not as suitable for the drawdown of floating particles. For any given upper impeller, the just drawdown agitation speeds for different combinations are almost same, though in multi-impeller stirred tanks the gas dispersion is controlled mainly by the bottom impeller. Of these impeller combinations, those using a HEDT as the bottom impeller have the flattest RPD and the highest gas holdup at a given gas flow rate and power input. The optimal impeller combination for to achieve both the drawdown of floating particles and gas dispersion is HEDT+WHD+WHU.

Solid-liquid suspension behavior intensified by punched rigid-flexible impeller

CFD-PBM Investigation on Droplet Size Distribution in a Liquid–Liquid Stirred Tank: Effect of Impeller Type

CFD Simulation of Solid Suspension in a Stirred Reactor Driven by a Dual Punched Rigid-Flexible Impeller

Numerical Study on Solid Suspension Characteristics of a Coaxial Mixer in Viscous Systems

Experimental Investigation on Solid Particle Distribution in Dense Solid–liquid Stirred Tank

Numerical simulation of solid-liquid suspension in a stirred tank with a dual punched rigid-flexible impeller

Experimental Investigation on Drawdown of Floating Particles in Viscous Systems Driven by Coaxial Mixers

Experimental Study on the Mixing and Dispersing of Floating Particles in Viscous System

Suspension of Buoyant Particles in a Three Phase Stirred Tank

GAS DISPERSION AND SOLID SUSPENSION IN A THREE-PHASE STIRRED TANK WITH MULTIPLE IMPELLERS

Numerical investigation on the intensification of coaxial slurry mixing systems

Design of impeller blades for efficient homogeneity of solid-liquid suspension in a stirred tank reactor

Numerical Simulation of Dense Solid-Liquid Mixing in Stirred Vessel with Improved Dual Axial Impeller

Intensification of Solid–Liquid Suspension Performance in an Elliptical Uncovered Unbaffled Stirred Tank

Solid-liquid mixing performance in a stirred tank with a double punched rigid-flexible impeller coupled with a chaotic motor

Fluid structure interaction in liquid mixing intensified by flexible rigid impeller

CFD Simulation of the Mixing and Dispersing of Floating Particles in a Viscous System

Improved suspension quality and liquid level stability in stirred tanks with Rotor-Stator agitator based on CFD simulation

Numerical Simulation of Solid-Liquid Mixing Characteristics in a Stirred Tank with Fractal Impellers

Experimental Investigation on Solid Suspension Performance of Coaxial Mixer in Viscous and High Solid Loading Systems

Study on mixing characteristics of viscoplastic fluid in a rigid-flexible impeller stirred tank